English
Language : 

XC2700 Datasheet, PDF (55/62 Pages) Infineon Technologies AG – 16/32-Bit Single-Chip Microcontroller
XC2700 Derivatives
XC2000 Family / Alpha Line
Detailed Errata Description
3. Clear the PVC interrupt request flag source SCU_DMPMITCLR.PVCMI2.
4. Clear the PVC interrupt request flag by writing to SCU_INTCLR.PVCMI2.
5. Clear the selected SCU request flag (default is SCU_1IC.IR).
RESET_X.H003 How to Trigger a PORST after an Internal Failure
There is no internal User Reset that restores the complete device including the power
system like a Power-On Reset. In some applications it is possible to connect ESR1 or
ESR2 with the PORST pin and set the used ESR pin as Reset output. With this a WDT
or Software Reset can trigger a Power-On Reset.
A detailed description is in the Application Note AP16103.
RTC_X.H003 Changing the RTC Configuration
The count input clock fRTC for the Real Time Clock module (RTC) can be selected via bit
field RTCCLKSEL in register RTCCLKCON. Whenever the system clock is less than 4
times faster than the RTC count input clock (fSYS < fRTC × 4), Asynchronous Mode must
be selected (bit RTCCM = 1B in register RTCCLKCON).
To assure data consistency in the count registers T14, RTCL, RTCH, the RTC module
must be temporarily switched off by setting bit MODEN = 0B in register RTC_KSCCFG
before register RTCCLKCON is modified, i.e. whenever
• changing the operating mode (Synchronous/Asynchronous) Mode in bit RTCCM, or
• changing the RTC count source in bit field RTCCLKSEL.
In case power domain DMP_1 is switched off, it is not required to switch the RTC to
Asynchronous Mode, since it will receive a reset in any case.
StartUp_X.H002 FCONCS0..FCONCS4 Registers are Always Configured in
External Start-Up Mode
The Start-Up procedure in External Start Mode writes all the FCONCSx (x=0..4) registers,
independently on the number of CS-outputs selected.This has no effect for the user
because for unused CS lines the Start-Up procedure configures only the external bus
type into the registers but does not enable the output(s) for CS-functionality and they are
free available.
Errata Sheet
55
V1.7, 2014-10