MC68HLC908QY4 Datasheet, PDF (53/182 Pages) Motorola, Inc – Microcontrollers

Chapter 5
Configuration Register (CONFIG)
5.1 Introduction
This section describes the configuration registers (CONFIG1 and CONFIG2). The configuration registers
enable or disable the following options:
• Stop mode recovery time (32 × BUSCLKX4 cycles or 4096 × BUSCLKX4 cycles)
• STOP instruction
• Computer operating properly module (COP)
• COP reset period (COPRS): 8176 × BUSCLKX4 or 262,128 × BUSCLKX4
• Low-voltage inhibit (LVI) enable and trip voltage selection
• OSC option selection
• IRQ pin
• RST pin
• Auto wakeup timeout period
5.2 Functional Description
The configuration registers are used in the initialization of various options. The configuration registers can
be written once after each reset. Exceptions are bits LVDLVR and LVIRSTD which may be written at any
time. Most of the configuration register bits are cleared during reset. Since the various options affect the
operation of the microcontroller unit (MCU) it is recommended that this register be written immediately
after reset. The configuration registers are located at $001E and $001F, and may be read at anytime.
Address: $001E
Bit 7
6
5
4
3
2
1
Read:
IRQPUD IRQEN
R
OSCOPT1 OSCOPT0
R
R
Write:
Reset: 0
0
0
0
0
0
0
POR: 0
0
0
0
0
0
0
R
= Reserved
U = Unaffected
Figure 5-1. Configuration Register 2 (CONFIG2)
Bit 0
RSTEN
U
0
MC68HLC908QY/QT Family Data Sheet, Rev. 3
Freescale Semiconductor
53