MC68HLC908QY4 Datasheet, PDF (131/182 Pages) Motorola, Inc – Microcontrollers

Input/Output Registers
Setting MS0B disables the channel 1 status and control register and reverts TCH1 to general-purpose
I/O.
Reset clears the MSxB bit.
1 = Buffered output compare/PWM operation enabled
0 = Buffered output compare/PWM operation disabled
MSxA — Mode Select Bit A
When ELSxB:A ≠ 00, this read/write bit selects either input capture operation or unbuffered output
compare/PWM operation.
See Table 14-3.
1 = Unbuffered output compare/PWM operation
0 = Input capture operation
When ELSxB:A = 00, this read/write bit selects the initial output level of the TCHx pin (see Table 14-3).
Reset clears the MSxA bit.
1 = Initial output level low
0 = Initial output level high
NOTE
Before changing a channel function by writing to the MSxB or MSxA bit, set
the TSTOP and TRST bits in the TIM status and control register (TSC).
Table 14-3. Mode, Edge, and Level Selection
MSxB
X
X
0
0
0
0
0
0
0
1
1
1
MSxA
0
1
0
0
0
1
1
1
1
X
X
X
ELSxB
0
0
0
1
1
0
0
1
1
0
1
1
ELSxA
0
0
1
0
1
0
1
0
1
1
0
1
Mode
Output preset
Input capture
Output compare
or PWM
Buffered output
compare or
buffered PWM
Configuration
Pin under port control; initial output level high
Pin under port control; initial output level low
Capture on rising edge only
Capture on falling edge only
Capture on rising or falling edge
Software compare only
Toggle output on compare
Clear output on compare
Set output on compare
Toggle output on compare
Clear output on compare
Set output on compare
ELSxB and ELSxA — Edge/Level Select Bits
When channel x is an input capture channel, these read/write bits control the active edge-sensing logic
on channel x.
When channel x is an output compare channel, ELSxB and ELSxA control the channel x output
behavior when an output compare occurs.
MC68HLC908QY/QT Family Data Sheet, Rev. 3
Freescale Semiconductor
131