MC3630 Datasheet, PDF (24/83 Pages) –

MC3630 3-Axis Accelerometer
Preliminary Datasheet
Reload
The device registers can be reloaded from OTP via an I2C or SPI instruction. Writing 0x1 into
register 0x24[7] causes a reload operation to execute. The contents of OTP are reloaded into
the register set. However any non-loaded register locations will not be affected. No attempt
should be made to access registers within 1mSec after issuing this operation. The device must
be placed in STANDBY mode before executing the reset.
The pin DOUT_A1 is sampled for the purposes of setting the I2C device address after this
reload operation.
mCube Proprietary
© 2016 mCube Inc. All rights Reserved
APS-048-0047v1.2
24 / 83