EPF10K30E Datasheet, PDF (96/100 Pages) Altera Corporation – Embedded Programmable Logic Device

FLEX 10KE Embedded Programmable Logic Devices Data Sheet
Figure 31. FLEX 10KE I_CCACTIVE vs. Operating Frequency (Part 2 of 2)
EPF10K130E
400
EPF10K200E
600
300
I_CC Supply
Current (mA) 200
100
400
I_CC Supply
Current (mA)
200
0
50
100
0
Frequency (MHz)
EPF10K200S
600
I_CC Supply
400
Current (mA)
200
50
100
Frequency (MHz)
0
50
100
Frequency (MHz)
Configuration &
Operation
The FLEX 10KE architecture supports several configuration schemes. This
section summarizes the device operating modes and available device
configuration schemes.
Operating Modes
The FLEX 10KE architecture uses SRAM configuration elements that
require configuration data to be loaded every time the circuit powers up.
The process of physically loading the SRAM data into the device is called
configuration. Before configuration, as V_CC rises, the device initiates a
Power-On Reset (POR). This POR event clears the device and prepares it
for configuration. The FLEX 10KE POR time does not exceed 50 µs.
When configuring with a configuration device, refer to the respective
configuration device data sheet for POR timing information.
96
Altera Corporation