W83627EHF Datasheet, PDF (20/141 Pages) Winbond – evolving product from Winbonds most popular I/O family

W83627EHF/EF, W83627EHG/EG
Serial Port & Infrared Port Interface, continued
SYMBOL
DTRB#
GP44*
SINA
GP63
SINB
IRRX
PIN
I/O
FUNCTION
81
OUT₈
UART B Data Terminal Ready. An active low signal informs the
modem or data set that controller is ready to communicate.
I/OD_8t General purpose I/O port 4 bit 4.
53
IN_t
Serial Input. It is used to receive serial data through the
communication link.
I/OD₈ General purpose I/O port 6 bit 3.
Serial Input. It is used to receive serial data through the
IN_t
communication link.
82
IR Receiver input.
GP43***
SOUTA
I/OD₁₂
OUT₈
General purpose I/O port 4 bit 3.
UART A Serial Output. It is used to transmit serial data out to the
communication link.
PENKBC
54
During power on reset, this pin is pulled down internally(20K ±
IN_t
30%)and is defined as PENKBC, which provides the power on
value for CR24 bit 2. A 1 kΩ is reserved to pull down and a 1 kΩ
is recommended if intends to pull up.
GP62
SOUTB
IRTX
I/O₈ General purpose I/O port 6 bit 2.
UART B Serial Output. It is used to transmit serial data out to the
OUT₈ ^{communication link.}
83
IR Transmitter output.
GP42*
DCDA#
GP61
DCDB#
GP41***
RIA#
I/OD₈ General purpose I/O port 4 bit 2.
56
IN_t
Data Carrier Detect. An active low signal indicates the modem or
data set has detected a data carrier.
I/OD₁₂ General purpose I/O port 6 bit 1.
84
IN_t
Data Carrier Detect. An active low signal indicates the modem or
data set has detected a data carrier.
I/OD₁₂ General purpose I/O port 4 bit 1.
57
IN_t
Ring Indicator. An active low signal indicates that a ring signal is
being received from the modem or data set.
GP60
RIB#
GP40*
57 I/OD₁₂ General purpose I/O port 6 bit 0.
85
IN_t
Ring Indicator. An active low signal indicates that a ring signal is
being received from the modem or data set.
I/OD₁₂ General purpose I/O port 4 bit 0.
Note. The * sign see 5.10.8 GPIO-1 and GPIO-4 with WDTO# / SUSLED / PLED multi-function
-14-