|
LM3S5K36 Datasheet, PDF (58/1050 Pages) Texas Instruments – Stellaris® LM3S5K36 Microcontroller | |||
|
◁ |
Architectural Overview
1.3.4.7
first time-out, and to generate a reset signal on its second time-out. Once the Watchdog Timer has
been configured, the lock register can be written to prevent the timer configuration from being
inadvertently altered.
The LM3S5K36 microcontroller has two Watchdog Timer modules: Watchdog Timer 0 uses the
system clock for its timer clock; Watchdog Timer 1 uses the PIOSC as its timer clock. The Stellaris
Watchdog Timer module has the following features:
â 32-bit down counter with a programmable load register
â Separate watchdog clock with an enable
â Programmable interrupt generation logic with interrupt masking
â Lock register protection from runaway software
â Reset generation logic with an enable/disable
â User-enabled stalling when the microcontroller asserts the CPU Halt flag during debug
Programmable GPIOs (see page 404)
General-purpose input/output (GPIO) pins offer flexibility for a variety of connections. The Stellaris
GPIO module is comprised of five physical GPIO blocks, each corresponding to an individual GPIO
port. The GPIO module is FiRM-compliant (compliant to the ARM Foundation IP for Real-Time
Microcontrollers specification) and supports 0-33 programmable input/output pins. The number of
GPIOs available depends on the peripherals being used (see âSignal Tablesâ on page 964 for the
signals available to each GPIO pin).
â Up to 33 GPIOs, depending on configuration
â Highly flexible pin muxing allows use as GPIO or one of several peripheral functions
â 5-V-tolerant in input configuration
â Two means of port access: either Advanced High-Performance Bus (AHB) with better back-to-back
access performance, or the legacy Advanced Peripheral Bus (APB) for backwards-compatibility
with existing code
â Fast toggle capable of a change every clock cycle for ports on AHB, every two clock cycles for
ports on APB
â Programmable control for GPIO interrupts
â Interrupt generation masking
â Edge-triggered on rising, falling, or both
â Level-sensitive on High or Low values
â Bit masking in both read and write operations through address lines
â Can be used to initiate an ADC sample sequence
â Pins configured as digital inputs are Schmitt-triggered
â Programmable control for GPIO pad configuration
58
January 21, 2012
Texas Instruments-Production Data
|
▷ |