LM3S300-IQN25-C2 Datasheet, PDF (269/498 Pages) Texas Instruments – Stellaris LM3S300 Microcontroller

NRND: Not recommended for new designs.
Stellaris^® LM3S300 Microcontroller
=1 configuration). For this example, the start value is GPTMTnIRL=0xC350 and the match value is
GPTMTnMATCHR=0x411A.
Figure 8-4. 16-Bit PWM Mode Example
Count
GPTMTnR=GPTMnMR
0xC350
GPTMTnR=GPTMnMR
0x411A
TnEN set
Output
Signal
TnPWML = 0
TnPWML = 1
Time
8.4
8.4.1
Initialization and Configuration
To use the general-purpose timers, the peripheral clock must be enabled by setting the TIMER0,
TIMER1, and TIMER2 bits in the RCGC1 register.
This section shows module initialization and configuration examples for each of the supported timer
modes.
32-Bit One-Shot/Periodic Timer Mode
The GPTM is configured for 32-bit One-Shot and Periodic modes by the following sequence:
1. Ensure the timer is disabled (the TAEN bit in the GPTMCTL register is cleared) before making
any changes.
2. Write the GPTM Configuration Register (GPTMCFG) with a value of 0x0.
3. Set the TAMR field in the GPTM TimerA Mode Register (GPTMTAMR):
a. Write a value of 0x1 for One-Shot mode.
b. Write a value of 0x2 for Periodic mode.
4. Load the start value into the GPTM TimerA Interval Load Register (GPTMTAILR).
5. If interrupts are required, set the TATOIM bit in the GPTM Interrupt Mask Register (GPTMIMR).
June 18, 2012
269
Texas Instruments-Production Data