PDRP-2001 Datasheet, PDF (93/140 Pages) Systemsensor advanced ideas. – Deluge Preaction Control Panel

Read Status
Operating Instructions
4.16.1 FACP Configuration
Pressing 1 while viewing Read Status Screen #1 will display the type of configuration programmed
into the FACP (refer to "FACP CONFIG (Application Templates)" on page 50). As an example, if
Template 7 was programmed as the FACP configuration, the following screen will be displayed:
READ FACP CONFIG
TEMPLATE 7
SINGLE HAZARD
3 ZONE
4.16.2 Input Zones
Pressing 2 while viewing Read Status Screen #1 will cause the following screens to be displayed:
READ INPUT ZONES
1=ZONE 1
2=ZONE 2
3=ZONE 3
Pressing the down arrow key will allow the selection of Zones 4-6.
The operator selects the zone which is to be viewed by pressing the number corresponding to the
desired zone in each screen. For example, if 1 is pressed in the first screen, the display will change
to a screen similar to the following:
READ INPUT ZONE 1
Normal ^{PULL STATION}
PRESS TO VIEW
Pressing the down arrow key, while viewing the screen shown above, will allow the operator to
view additional programming information about the selected device, such as:
• Enable/Disable Status
• Device Type
• Output Circuit MAP
• Adjective/Noun descriptor
PDRP-2001 Series PN 53043:A 5/08/2007
93