PDRP-2001 Datasheet, PDF (55/140 Pages) Systemsensor advanced ideas. – Deluge Preaction Control Panel

Master Programming Level
Programming
Pressing 2 while viewing the Noun/Adjective Screen will cause the following screen(s) to be
displayed. Note that the keyboard down arrow key must be pressed to see all the Noun screens.
Press the number corresponding to the noun that is to be used as a descriptor for the location of
the detector currently being programmed. When a noun has been selected, it will appear at the
top of the display as indicated by the asterisks.
**********************
1=BASEMENT
2=BOILER RM
3=CLASSROOM
Noun Screen #1
**********************
1=HVAC RM
2=ISLAND
3=KITCHEN
Noun Screen #4
**********************
1=COMPUTER RM
2=CONTROL RM
3=DATA ROOM
Noun Screen #2
**********************
1=ROOM
2=STOREROOM
3=TELCO ROOM
Noun Screen #5
**********************
1=DOCUMENT RM
2=ELECTRIC RM
3=GARAGE
**********************
1=UPS ROOM
2=VAULT
Noun Screen #3
Noun Screen #6
INPUT ZONE #
1=NOUN/ADJECTIVE
2=DESCRIPTION
Edit Input Zone Screen #3
Description
The Description selection allows the programmer to enter additional information about the
detector currently being programmed. This information will be displayed as part of the device
label on the display. Pressing 2 while viewing Edit Input Zone Screen #3 will cause the
following screen to be displayed:
ZONE # DESCRIPTION
PRESS ENTER IF DONE
********************
Adjective/Noun Screen
A flashing cursor will appear at the first asterisk to the left. The programmer can enter
additional descriptive information about the device being programmed. This information will
appear on the display along with the standard device label information.
PDRP-2001 Series PN 53043:A 5/08/2007
55