PDRP-2001 Datasheet, PDF (48/140 Pages) Systemsensor advanced ideas. – Deluge Preaction Control Panel

Programming
Programming and Passwords
3.4 Programming and Passwords

See Page
There are two factory set programming passwords which will access the Programming screens as
indicated in the following examples. From either of the screens, access to specific system and
device features or programming may be obtained. All user programming entries are stored in
nonvolatile memory. The factory set passwords can be changed by the user as described in
"Password Change" on page 80. If an invalid password is entered, the blinking cursor will return to
the first password character position. To exit Programming or Read Status mode at any time, press
the ESC (Escape) key repeatedly. Note that as soon as program data is entered, the data is
automatically saved by the panel. If the Reset key is pressed or power is lost before exiting
Programming mode, the data just entered will not be lost.
To access user Programming mode, press the Enter or Mode key. The LCD will display the
following:
1=READ STATUS MODE
2=PROGRAMMING MODE
To enter the user Programming mode, press 2. The display will read as follows:
PROGRAMMING
ENTER PASSWORD
*****
Entering the Master level password (default 00000) will cause the following screen to appear:
PROGRAMMING
1=FACP CONFIG
T5
2=INPUT ZONES
3=OUTPUT CIRCUITS
Programming Screen #1
If the Maintenance level password (default 11111) is entered, the following screen will appear:
PROGRAMMING
1=INPUT ZONES
2=HISTORY
3=WALKTEST
Note that in the two preceding screens, an arrow appears to inform the programmer that additional
options can be viewed by pressing the keypad down arrow key.
48
PDRP-2001 Series PN 53043:A 5/08/2007