PIC16LF1454 Datasheet, PDF (60/418 Pages) Microchip Technology – 14/20-Pin Flash, 8-Bit USB Microcontrollers with XLP Technology

PIC16(L)F1454/5/9
FIGURE 5-3:
QUARTZ CRYSTAL
OPERATION (LP, XT OR
HS MODE)
PIC^® MCU
C1
Quartz
Crystal
OSC1/CLKIN
RF⁽²⁾
To Internal
Logic
Sleep
C2
RS⁽¹⁾
OSC2/CLKOUT
Note 1: A series resistor (RS) may be required for
quartz crystals with low drive level.
2: The value of RF varies with the Oscillator mode
selected (typically between 2 M to 10 M.
Note 1: Quartz crystal characteristics vary
according to type, package and
manufacturer. The user should consult the
manufacturer data sheets for specifications
and recommended application.
2: Always verify oscillator performance over
the VDD and temperature range that is
expected for the application.
3: For oscillator design assistance, reference
the following Microchip Applications Notes:
• AN826, “Crystal Oscillator Basics and
Crystal Selection for rfPIC^® and PIC^®
Devices” (DS00826)
• AN849, “Basic PIC^® Oscillator Design”
(DS00849)
• AN943, “Practical PIC^® Oscillator
Analysis and Design” (DS00943)
• AN949, “Making Your Oscillator Work”
(DS00949)
FIGURE 5-4:
CERAMIC RESONATOR
OPERATION
(XT OR HS MODE)
PIC^® MCU
OSC1/CLKIN
C1
To Internal
Logic
RP⁽³⁾
RF⁽²⁾
Sleep
C2 _{Ceramic RS}⁽¹⁾
Resonator
OSC2/CLKOUT
Note 1: A series resistor (RS) may be required for
ceramic resonators with low drive level.
2: The value of RF varies with the Oscillator mode
selected (typically between 2 M to 10 M.
3: An additional parallel feedback resistor (RP)
may be required for proper ceramic resonator
operation.
5.2.1.3 Oscillator Start-up Timer (OST)
If the oscillator module is configured for LP, XT or HS
modes, the Oscillator Start-up Timer (OST) counts 1024
oscillations from OSC1. This occurs following a
Power-on Reset (POR) and when the Power-up Timer
(PWRT) has expired (if configured), or a wake-up from
Sleep. During this time, the program counter does not
increment and program execution is suspended unless
either FSCM or Two-Speed Start-Up are enabled. In this
case, code will continue to execute at the selected
INTOSC frequency while the OST is counting . The OST
ensures that the oscillator circuit, using a quartz crystal
resonator or ceramic resonator, has started and is
providing a stable system clock to the oscillator module.
In order to minimize latency between external oscillator
start-up and code execution, the Two-Speed Clock
Start-up mode can be selected (see Section 5.6
“Two-Speed Clock Start-up Mode”).
DS41639A-page 60
Preliminary
 2012 Microchip Technology Inc.