PIC16LF1454 Datasheet, PDF (129/418 Pages) Microchip Technology – 14/20-Pin Flash, 8-Bit USB Microcontrollers with XLP Technology

12.0 I/O PORTS
Each port has three standard registers for its operation.
These registers are:
• TRISx registers (data direction)
• PORTx registers (reads the levels on the pins of
the device)
• LATx registers (output latch)
Some ports may have one or more of the following
additional registers. These registers are:
• ANSELx (analog select)
• WPUx (weak pull-up)
In general, when a peripheral is enabled on a port pin,
that pin cannot be used as a general purpose output.
However, the pin can still be read.
TABLE 12-1: PORT AVAILABILITY PER
DEVICE
Device
PIC16(L)F1454/5
PIC16(L)F1459
●
●
●
●
●
The Data Latch (LATx registers) is useful for
read-modify-write operations on the value that the I/O
pins are driving.
A write operation to the LATx register has the same
effect as a write to the corresponding PORTx register.
A read of the LATx register reads of the values held in
the I/O PORT latches, while a read of the PORTx
register reads the actual I/O pin value.
Ports that support analog inputs have an associated
ANSELx register. When an ANSEL bit is set, the digital
input buffer associated with that bit is disabled.
Disabling the input buffer prevents analog signal levels
on the pin between a logic high and low from causing
excessive current in the logic input circuitry. A
simplified model of a generic I/O port, without the
interfaces to other peripherals, is shown in Figure 12-1.
PIC16(L)F1454/5/9
FIGURE 12-1:
GENERIC I/O PORT
OPERATION
Read LATx _TRISx
Write LATx
Write PORTx
D
Q
CK
Data Register
Data Bus
Read PORTx
To peripherals
ANSELx
VDD
I/O pin
VSS
EXAMPLE 12-1: INITIALIZING PORTA
; This code example illustrates
; initializing the PORTA register. The
; other ports are initialized in the same
; manner.
BANKSEL PORTA
;
CLRF
PORTA
;Init PORTA
BANKSEL LATA
;Data Latch
CLRF
LATA
;
BANKSEL ANSELA
;
CLRF
ANSELA
;digital I/O
BANKSEL TRISA
;
MOVLW B'00111000' ;Set RA<5:3> as inputs
MOVWF TRISA
;and set RA<2:0> as
;outputs
 2012 Microchip Technology Inc.
Preliminary
DS41639A-page 129