PIC16LF1454 Datasheet, PDF (237/418 Pages) Microchip Technology – 14/20-Pin Flash, 8-Bit USB Microcontrollers with XLP Technology

PIC16(L)F1454/5/9
22.6.4 I²C MASTER MODE START
CONDITION TIMING
To initiate a Start condition (Figure 22-26), the user
sets the Start Enable bit, SEN bit of the SSPCON2
register. If the SDA and SCL pins are sampled high,
the Baud Rate Generator is reloaded with the contents
of SSPADD<7:0> and starts its count. If SCL and SDA
are both sampled high when the Baud Rate Generator
times out (TBRG), the SDA pin is driven low. The action
of the SDA being driven low while SCL is high is the
Start condition and causes the S bit of the SSPSTAT1
register to be set. Following this, the Baud Rate Gen-
erator is reloaded with the contents of SSPADD<7:0>
and resumes its count. When the Baud Rate Genera-
tor times out (TBRG), the SEN bit of the SSPCON2 reg-
ister will be automatically cleared by hardware; the
Baud Rate Generator is suspended, leaving the SDA
line held low and the Start condition is complete.
Note 1: If at the beginning of the Start condition,
the SDA and SCL pins are already sam-
pled low, or if during the Start condition,
the SCL line is sampled low before the
SDA line is driven low, a bus collision
occurs, the Bus Collision Interrupt Flag,
BCLIF, is set, the Start condition is
aborted and the I²C module is reset into
its Idle state.
2: The Philips I²C™ Specification states that
a bus collision cannot occur on a Start.
FIGURE 22-26: FIRST START BIT TIMING
Write to SEN bit occurs here
Set S bit (SSPSTAT<3>)
SDA = 1,
SCL = 1
TBRG
TBRG
At completion of Start bit,
hardware clears SEN bit
and sets SSPIF bit
Write to SSPBUF occurs here
SDA
1st bit
2nd bit
SCL
TBRG
S
TBRG
 2012 Microchip Technology Inc.
Preliminary
DS41639A-page 237