PIC32MX1XX_12 Datasheet, PDF (317/328 Pages) Microchip Technology – 32-bit Microcontrollers (up to 128 KB Flash and 32 KB SRAM) with Audio and Graphics Interfaces, USB, and Advanced Analog

PIC32MX1XX/2XX
Revision E (October 2012)
All singular pin diagram occurrences of CVREF were
changed to: CVREFOUT. In addition, minor text and for-
matting changes were incorporated throughout the
document.
All major changes are referenced by their respective
section in Table A-4.
TABLE A-4: MAJOR SECTION UPDATES
Section
Update Description
“32-bit Microcontrollers (up to
128 KB Flash and 32 KB SRAM)
with Audio and Graphics
Interfaces, USB, and Advanced
Analog”
Updated the following feature sections:
• “Operating Conditions”
• “Communication Interfaces”
2.0 “Guidelines for Getting
Started with 32-bit MCUs”
Removed Section 2.8 “Configuration of Analog and Digital Pins During ICSP
Operations”.
3.0 “CPU”
Removed references to GPR shadow registers in 3.1 “Features” and
3.2.1 “Execution Unit”.
4.0 “Memory Organization”
Updated the BRG bit range in the SPI1 and SPI2 Register Map (see Table 4-8).
Added the PWP<6> bit to the Device Configuration Word Summary
(see Table 4-17).
5.0 “Flash Program Memory” Added a note with Flash page size and row size information.
7.0 “Interrupt Controller”
Updated the TPC<2:0> bit definitions (see Register 7-1).
Updated the IPTMR<31:0> bit definition (see Register 7-3).
8.0 “Oscillator Configuration”
Updated the PIC32MX1XX/2XX Family Clock Diagram (see Figure 8-1).
Updated the RODIV<14:0> bit definitions (see Register 8-3).
10.0 “USB On-The-Go (OTG)” Updated the Notes in the USB Interface Diagram (see Figure 10-1).
18.0 “Universal Asynchronous Updated the baud rate range in the list of primary features.
Receiver Transmitter (UART)”
26.0 “Special Features”
Added the PWP<6> bit to the Device Configuration Word 0
(see Register 26-1).
29.0 “Electrical Characteristics” Added Note 1 to Operating MIPS vs. Voltage (see Table 29-1).
Added Note 2 to DC Temperature and Voltage Specifications (see Table 29-4).
Updated the Conditions for parameter DC25 in DC Characteristics: Operating
Current (IDD) (see Table 29-5).
Added Note 2 to Electrical Characteristics: BOR (see Table 29-10).
Added Note 4 to Comparator Specifications (see Table 29-12).
Added Note 5 to ADC Module Specifications (see Table 29-32).
Updated the 10-bit Conversion Rate Parameters and added Note 3 (see
Table 29-33).
Added Note 4 to the Analog-to-Digital Conversion Timing Requirements (see
Table 29-34).
Added Note 3 to CTMU Current Source Specifications (see Table 29-39).
30.0 “50 MHz Electrical
Characteristics”
New chapter with electrical characteristics for 50 MHz devices.
31.0 “Packaging Information” The 36-pin and 44-pin VTLA packages have been updated.
 2011-2012 Microchip Technology Inc.
Preliminary
DS61168E-page 317