409-10029 Datasheet, PDF (8/31 Pages) Tyco Electronics – When reading this manual, pay particular attention to DANGER, CAUTION, and NOTE statements.

Stripping Module 1490503-[ ] and 1490501-[ ]
409-10029
Gripper
Pressure
Regulator
Right
Guard
Rear View
Pneumatic
Assembly
Figure 4
2. The gripper jaws then close on the wire while the strip blades close to cut through the insulation. The
stripping mechanism pulls the blades away from the operator to remove the insulation slug.
3. The stripping unit shifts to the “right side position” to remove the stripping blades from the applicator.
4. The terminator cycles to crimp a terminal onto the wire.
5. After completing the crimp, the grippers open to release the crimped wire and the stripping blades
retract.
6. The start sensor arm then retracts so that the air blast can blow the insulation slug into the scrap bin.
7. The stripping unit then transfers back to the start position.
3. RECEIVING INSPECTION AND INSTALLATION
3.1. Receiving Inspection
The stripping module is thoroughly inspected during and after assembly. A final series of inspections is made to
insure the proper machine functioning before packaging and shipping.
To protect against damage that may have occurred during shipment, remove the machine from the packaging
and carefully inspect the machine for damage. If damage is evident, file a claim against the carrier and
immediately notify Tyco Electronics.
DANGER
To avoid personal injury, be sure to turn off" and disconnect power to the machine.
3.2. Installation of the Stripping Module Field Kit 1490503 -[ ] in Model G" Terminator
Remove the module from the packaging and install the field kit to the machine as follows:
A. AMP-O-LECTRIC Model G" Terminator Preparation
1. Disconnect electrical and pneumatic power supplies.
8 of 31
Tyco Electronics Corporation
Rev C