409-10029 Datasheet, PDF (7/31 Pages) Tyco Electronics – When reading this manual, pay particular attention to DANGER, CAUTION, and NOTE statements.

Stripping Module 1490503-[ ] and 1490501-[ ]
Strip Cylinder
409-10029
Strip Cam
Main Block
Start Sensor
Assembly
Outer Strip
Blade
Figure 3 (Sheet 2 of 2)
2.2. Electrical Description
The stripping module electrical components consist of the operator control panel, the electrical enclosure,
electrically controlled pneumatic valves, and various switches and sensors. The control module operates on
100/240 VAC, 50/60 HZ, single–phase current, with ground. Power for the stripping module is supplied by the
Model “G” Terminating Machine. The machine power switch turns on both the “G” Terminating Machine and the
stripping module. A main power switch/circuit breaker is located on the left of the machine electrical enclosure.
The operator control panel is attached to the electrical enclosure and is mounted on the left side of the
machine. See Figure 1. The control panel consists of 12 indicator lights and 8 keys with icons depicting each
function. Refer to Figure 9.
2.3. Machine Guards
A combination of guards is installed to provide protection for the operator while maintaining proper visibility of
the work area. The left guard (Figure 1) swings open to the left and the right guard (Figure 1) swings open to
the right to allow easy access for applicator installation and setup. Safety interlocks on the guards prevent the
machine from cycling if the guard doors are open during production operation.
2.4. Description of Operation
The strip and crimp cycle of operation is as follows:
1. The cycle may be started automatically (with “Start Sensor” selected as the starting means), or with
the foot switch. In automatic operation (“Start Sensor” selected as the starting means), the operator
places a wire through the grip jaws and strip blades to depress the start sensor, which automatically
starts the cycle . If the foot switch was selected as the starting means, the operator depresses the foot
switch to activate the cycle.
Rev C
Tyco Electronics Corporation
7 of 31