409-10029 Datasheet, PDF (17/31 Pages) Tyco Electronics – When reading this manual, pay particular attention to DANGER, CAUTION, and NOTE statements.

Stripping Module 1490503-[ ] and 1490501-[ ]
Mode Selection
Button
Single Step
Button
Wire Sensor / Footswitch
Selector Button
409-10029
Air Blast Duration
Select Button
Main Air ON
Button and
LED
Main Air ON
and OFF
Button and
LED
Transfer Return
Delay Select
Button
Pullback
Error Icon
and LED
Transfer
Error Icon
and LED
Terminator
Error Icon
and LED
Error Reset
Button and LED
Pushing the Main Air ON Button causes the main air valve to pulse, homing" the stripping mechanism.
Power ON LED After "homing," the mechanism returns to the start position for mode selected. The
will turn
on" when the power on sequence is complete.
Rev C
Pressing the Main Air OFF Button turns off the main air valve, removing pneumatic power. The Main Air
OFF LED will be on" when the main air valve is turned off."
The Mode Selection Button toggles the machine mode to the next mode. The three
available modes include: Strip and Crimp Mode (top); Crimp Only Mode (middle);
and Strip Mode Only (bottom). Each press of the button toggles the machine beĆ
tween modes.
Note that the Main Air must be OFF to change modes.
Note that the Crimp Only Mode precludes the use of the wire sensor for starting the
cycle.
The corresponding LEDs designate the currently selected mode.
Pushing the Wire Sensor Button toggles between the Wire Sensor method (top) and the Footswitch
method (bottom) of operation. Only one method of starting can be selected for operation. The Wire
Sensor LED will indicate the selected method of operation.
The wire sensor method of operation is used in the Strip and Crimp Mode and the Strip Only Mode.
The footswitch method of operation is used for all modes. In addition, the Footswitch LED will turn
on" during Single Step Operation to indicate that a terminator cycle may occur, either by jogging
with the foot switch or automatic cycle by pressing the foot switch. Jog or Automatic Mode is
selected on the Model G" Terminating Machine control panel.
Pressing and holding the Single Step Button places the system in single step operation. Each additional
press of the button initiates the next step of the machine cycle. When the cycle is complete, the system
will return to normal operation and the Single Step LED will be turned off.
Figure 9 (Sheet 1 of 3)
Tyco Electronics Corporation
17 of 31