409-10029 Datasheet, PDF (11/31 Pages) Tyco Electronics – When reading this manual, pay particular attention to DANGER, CAUTION, and NOTE statements.

Stripping Module 1490503-[ ] and 1490501-[ ]
409-10029
R50
R55
R58
R49
R46
R40
R54
R60
R30
R52
R51
C14
R14 R31
R53
R61
R47
R56
R48
R42
C12
R57
U4
U9
U12
R43
J1
R44
R38
R45
R39
U11
Jumper W1,
Positions 2 & 3
Q1 _R15 C13
C15
R2
R4
R16
R3
C8
Q2 _{R18 R20}
C16
R10
DS1
U2
U10
C10
Q3 R19
R17
R21
RT3
TP4 TP5
C6
J5 ^R68
12 3
R85
C11
12 3
U19
U22 _W4
Q6
DS9 ^{R37 U13}
R9
A
R69
DS8 ^R36
A
U17
DS7 R35
A
DS6 R34
A
U6
DS5 R33
A
DS4 R32 _R22
A
DS3
A
DS2
A
R70
U8
R11
R71
R64
J2
R73
U15
R12 R72
R5
R6
U23
R13
U18
J3
U14
U16
R24
R26
R62
R76 R75
R78 R77
R29
CR1
U20
R27
R28
Q7
R25
W3
PCB #1583680–1
ASSY #1583681–
J4
REV A
REV
J9
R83
R79
R23
J6 R82
U21
32
1 W2
R74
Figure 5
S Install ground wire to ground stud inside control box.
d. Attach original foot switch connector to the CPC connector in the back of the control box (refer to
Drawing 1490843, Sheet 11).
27. Install the following to the Model “G” Terminator electrical box (refer to Drawing 1490843):
a. Install the Foot Switch Signal Cable S to the original foot switch connector on the underside of the
electrical box (refer to Sheet 14).
b. Install AC Power Cable H (refer to Drawing 1490843, Sheets 15 and 16):
S Install brown wire (P20) onto Terminal 3 of rocker switch.
S Install blue wire (P19) onto Terminal 4 of rocker switch.
S Install brown wire from the Model “G” Terminator back onto piggy–back connector on Terminal 3.
S Install blue wire from the Model “G” Terminator back onto piggy–back connector on Terminal 4.
S Remove and discard grommet from Model “G” Terminator control box.
S Pass the AC power cable through the opening in the control box.
Rev C
Tyco Electronics Corporation
11 of 31