409-10029 Datasheet, PDF (28/31 Pages) Tyco Electronics – When reading this manual, pay particular attention to DANGER, CAUTION, and NOTE statements.

Stripping Module 1490503-[ ] and 1490501-[ ]
.25mm [.010 In.]
409-10029
Figure 14
8. ELECTRICAL ASSEMBLY
Refer to the electrical assembly drawings shipped with the machine.
9. PARTS REPLACEMENT
9.1. Strip Blade Replacement (Figure 15)
DANGER
To avoid personal injury, be sure to disconnect power to the terminating machine and stripping module and before
replacing strip blades.
1. Turn power to the stripping module OFF.
2. Loosen the screws securing the scrap covers. Then slide the scrap covers off.
3. Remove the outer blade by removing the two screws securing the blade to the main block.
4. Remove the inner blade by removing the single screw securing the blade to the blade adjustment
block.
5. Install new blades (replacement is in reverse order of removal).
6. Check the strip depth after removing/replacing the blades. Adjustment may be required.
9.2. Start Sensor Assembly Replacement (Figure 15)
DANGER
To avoid personal injury, be sure to disconnect power to the terminating machine and stripping module before
replacing the start sensor.
1. Turn power to the stripping module OFF.
2. Remove the cable clamp from the rear of the strip cylinder.
3. Remove the three screws securing the start sensor assembly to the start sensor block.
4. Install the new start sensor assembly onto the start sensor block by installing the two outer screws
into the block and loosely tightening them.
5. Turn the strip length screw (Figure 12) clockwise until the main block is 10.16 [.400] from the strip
cam stop plate. See Figure 16.
6. Adjust the start sensor arm so that the lever is 4.78 [.188] from the back of cutting surface of the
outer strip cam.
NOTE
i
When adjusting the outer strip arm, be sure that the start sensor block is pushed forward against the strip length
adjustment screw.
28 of 31
Tyco Electronics Corporation
Rev C