409-10029 Datasheet, PDF (14/31 Pages) Tyco Electronics – When reading this manual, pay particular attention to DANGER, CAUTION, and NOTE statements.

Stripping Module 1490503-[ ] and 1490501-[ ]
Optional Lift Ring
409-10029
Figure 6
Connect the foot switch to the connector on the rear of the stripping module control box.
Connect the power cord to a suitable electrical supply.
NOTE
The machine will automatically detect the supply voltage and adjust the controller accordingly.
i
NOTE
i
Models exported to Europe will be installed by Tyco Electronics Service Representatives. These representatives will
verify that the electrical and pneumatic connections are correct. Both pneumatic and electrical connections must be
installed in a way that provides a lockable isolation switch for hard-wired or direct piped machines. This is necessary
to interrupt power to the machine for setup or maintenance.
Connect the pneumatic assembly to a suitable air supply.
Turn the machine “on” in the INPUT MONITORING Mode and check for proper functioning of the machine
inputs by manually cycling the stripping module. Refer to Paragraph 6.2.
When the unit appears to be functioning properly proceed as follows:
1. Remove the applicator.
2. Manually return the terminator ram to the top of its travel (TDC).
3. Connect air and turn “on” the main air shut–off valve.
4. Close the guard
5. Power up the stripping module by pressing the green Power Up Button.
6. Check for errors that may have occurred while the machine was being turned on.
7. Use the error code table in Paragraph 4.5 to diagnose and correct any errors.
3.4. Considerations Affecting Placement of Bench Machines
The location of the machine in relation to the operator’s position is extremely important in terms of both safety
and maximum efficiency. Studies have repeatedly shown that operator fatigue will be reduced, and greater
efficiency achieved, if: (1) the bench is of appropriate height, preferably with sound–deadening rubber mounts;
(2) the machine is properly located on the bench with ample work areas on both sides to facilitate work flow;
(3) the operator uses a swivel chair with padded seat and back rest which are independently adjustable; and
14 of 31
Tyco Electronics Corporation
Rev C