409-10029 Datasheet, PDF (15/31 Pages) Tyco Electronics – When reading this manual, pay particular attention to DANGER, CAUTION, and NOTE statements.

Stripping Module 1490503-[ ] and 1490501-[ ]
409-10029
(4) the foot switch, on machines so equipped, is placed on a rubber mat to maintain its movability, while
preventing it from sliding unintentionally. Figure 7 illustrates proper machine location and operator position.
Figure 8 illustrates:
1. Bench
The bench to be used should be of sturdy construction, preferably with rubber mounts to minimize noise.
A height of 762.0mm to 812.8mm [30 in. to 32 in.] is the most suitable for operator comfort and
convenience. This height allows the operator to rest both feet on the floor, thereby providing for the
shifting of weight and leg position.
2. Machine Location on Bench
The machine should be located near the front of the bench with the “target area” (tooling area where the
product is applied) not more than 152.4mm to 203.2mm [6 in. to 8 in.] from the front edge. This location
will eliminate unnecessary operator motion and help to avoid back strain and fatigue.
Orientation of the machine should be such that the “target area” is facing the front of the bench and is
parallel to the front edge. (Access to the back of the machine MUST also be provided.)
3. Operator’s Chair
The operator’s chair should swivel, and should have independent seat height and back rest adjustments.
The seat and back rest should be padded, and the back rest should be large enough to provide support
both above and below the waist line.
In use, the chair should be far enough under the bench so that the operator’s back is straight and is
supported by the back rest.
Rev C
Figure 7
Materials Locations Ċ Plan View
Supply
Applied
Product
Figure 8
Tyco Electronics Corporation
15 of 31