|
409-10029 Datasheet, PDF (4/31 Pages) Tyco Electronics – When reading this manual, pay particular attention to DANGER, CAUTION, and NOTE statements. | |||
|
◁ |
Stripping Module 1490503-[ ] and 1490501-[ ]
409-10029
1. INTRODUCTION
This manual contains information on the operation, adjustments and preventive maintenance of Stripping
Modules 1490503â[ ] (field retrofit kits) and 1490501â[ ] (factory installed stripping modules), used in
conjunction with the AMPâOâLECTRIC* Model âGâ Terminating Unit. See Figure 1.
For information concerning the Model âGâ Terminating Unit, refer to 409â5842 and any documentation
included with the terminator.
Most sideâfeed and endâfeed heavyâduty mini applicators and lightâduty mini applicators can be run with
stripping modules. Slight modifications may be required to run these applicators; most modifications involve
removing the wire stop. Refer to Paragraph 4.2. (Applicator Setup and Installation) of this manual.
Refer to the applicator instruction sheet and documentation included with the applicators for operation,
adjustment, and preventive maintenance of the applicators.
When reading this manual, pay particular attention to DANGER, CAUTION, and NOTE statements.
DANGER Denotes an imminent hazard which may result in moderate or severe injury.
CAUTION Denotes a condition which may result in product or equipment damage.
!
NOTE
Highlights special or important information.
i
2. DESCRIPTION
Stripping Modules 1490503â[ ] and 1490501â[ ] are pneumatically driven, microprocessor controlled, inâline
stripping modules designed to be used to provide wire stripping capability to the Model âGâ Terminating
Machine. These stripping modules accept a wide range of wire insulation types.
The stripping modules are assembled with metric hardware.
NOTE
i
Measurements are in metric units [followed by U.S. customary units in brackets]. Some commercial items may contain
non-metric hardware.
4 of 31
Tyco Electronics Corporation
Rev C
|
▷ |