409-10029 Datasheet, PDF (25/31 Pages) Tyco Electronics – When reading this manual, pay particular attention to DANGER, CAUTION, and NOTE statements.

Stripping Module 1490503-[ ] and 1490501-[ ]
409-10029
1. Turn “off” power to the terminating machine and stripping module.
2. Place a wire onto the lower jaw (Figure 13) and insert the wire through the opening in the strip blades.
3. Center the wire in the center of the “V” opening in the outer blade by turning the jaw–height
adjustment screw located on the top of the right gib of the grip sub–assembly. Turning the adjustment
screw clockwise will lower the jaw. Turning the adjustment screw counterclockwise will raise the gripper
jaw.
B. Gripper Pressure Adjustment
The gripper pressure adjustment may be necessary to prevent damage to the wire insulation.
To see the pressure level on the gage, enter the Step Mode while in Strip And Crimp Mode or Strip Only
Mode. Perform the first step by pressing the step button. This will close the grip jaw and the pressure will
be displayed on the gage next to the gripper pressure regulator (Figure 1).
Strip Cylinder
Strip Cam Speed
Flow Control
Start Sensor
Block
Start Sensor
Assembly
Outer
Strip
Blade
Strip Cam
Pull-Back
Switch
Strip Blade
Drive Block
Strip Depth
Adjustment
Block
Strip Depth
Adjustment
Screw
Main
Block
Strip Length
Adjusting Screw
Stripping Subassembly
Figure 12
Wire Brush
Adjustment Screw
Strip Cam
Stop Plate
Inner Strip
Blade
Rev C
Tyco Electronics Corporation
25 of 31