BD82HM55-SLGZS Datasheet, PDF (342/956 Pages) Intel Corporation – Intel® 5 Series Chipset and Intel® 3400 Series Chipset

Electrical Characteristics
8.6
AC Characteristics
Table 8-17. PCI Express* Interface Timings
Symbol
Parameter
Min
Max
Unit Figures
Notes
Transmitter and Receiver Timings
UI
Unit Interval – PCI Express*
399.88 400.12 ps
5
T_TX-EYE
Minimum Transmission Eye
Width
0.7
—
UI
8-26
1,2
T_TX-RISE/ D+/D- TX Out put Rise/Fall
Fall
time
—
0.125
UI
1,2
T_RX-EYE Minimum Receiver Eye Width
0.40
—
UI
8-27
3,4
NOTES:
1.
Specified at the measurement point into a timing and voltage compliance test load and
measured over any 250 consecutive TX UIs. (Also refer to the Transmitter compliance eye
diagram).
2.
A T_TX-EYE = 0.70 UI provides for a total sum of deterministic and random jitter budget of
T_TXJITTER-MAX = 0.30 UI for the Transmitter collected over any 250 consecutive TX UIs. The
T_{TXEYE-MEDIAN-to-MAX-JITTER} specification ensures a jitter distribution in which the median
and the maximum deviation from the median is less than half of the total TX jitter budget
collected over any 250 consecutive TX UIs. It should be noted that the median is not the
same as the mean. The jitter median describes the point in time where the number of jitter
points on either side is approximately equal as opposed to the averaged time value.
3.
Specified at the measurement point and measured over any 250 consecutive UIs. The test
load documented in the PCI Express* specification 2.0 should be used as the RX device
when taking measurements (also refer to the Receiver compliance eye diagram). If the
clocks to the RX and TX are not derived from the same reference clock, the TX UI
recovered from 3500 consecutive UI must be used as a reference for the eye diagram.
4.
A T_RX-EYE = 0.40 UI provides for a total sum of 0.60 UI deterministic and random jitter
budget for the Transmitter and interconnect collected any 250 consecutive UIs. The T_RX-
EYE-MEDIAN-to--MAX-JITTER ^{specification ensures a jitter distribution in which the median and}
the maximum deviation from the median is less than half of the total 0.6 UI jitter budget
collected over any 250 consecutive TX UIs. It should be noted that the median is not the
same as the mean. The jitter median describes the point in time where the number of jitter
points on either side is approximately equal as opposed to the averaged time value. If the
clocks to the RX and TX are not derived from the same reference clock, the TX UI
recovered from 3500 consecutive UI must be used as the reference for the eye diagram.
5.
Nominal Unit Interval is 400 ps for 2.5 GT/s and 200 ps for 5 GT/s.
342
Datasheet