XRT72L58 Datasheet, PDF (188/486 Pages) Exar Corporation – EIGHT CHANNEL DS3/E3 FRAMER IC WITH HDLC CONTROLLER

XRT72L58
REV. P1.1.2
EIGHT CHANNEL DS3/E3 FRAMER IC WITH HDLC CONTROLLER
áç
PRELIMINARY
FRAMER OPERATING MODE REGISTER (ADDRESS = 0X00)
BIT 7
BIT 6
BIT 5
BIT 4
BIT 3
BIT2
BIT 1
BIT 0
Local Loopback
R/W
0
DS3/E3*
R/W
0
Internal LOS
Enable
R/W
1
RESET
R/W
0
Interrupt
Enable Reset
R/W
1
Frame Format
R/W
0
TimRefSel[1:0]
R/W
R/W
1
x
3. Interface the XRT72L58, to the Terminal Equip-
ment, as illustrated in Figure 54.
4.2.2 The Transmit Overhead Data Input Inter-
face
Figure 56 presents a simple illustration of the Trans-
mit Overhead Data Input Interface block within the
XRT72L58.
FIGURE 56. SIMPLE ILLUSTRATION OF THE TRANSMIT OVERHEAD DATA INPUT INTERFACE BLOCK
TxOHFrame
TxOHEnable
TxOH
TxOHClk
TxOHIns
TTrraannsmsmitit
OOvveerhrheeaadd
DDaatataInInppuut _t
InInteterfrafacceeBBlolocckk
To Transmit DS3 Framer Block
The DS3 Frame consists of 4760 bits. Of these bits,
4704 bits are payload bits and the remaining 56 bits
are overhead bits. The XRT72L58 has been de-
signed to handle and process both the payload type
and overhead type bits for each DS3 frame. Within
the Transmit Section within the XRT72L58, the Trans-
mit Payload Data Input Interface has been designed
to handle the payload data. Likewise, the Transmit
Overhead Data Input Interface has been designed to
handle and process the overhead bits.
The Transmit Section of the XRT72L58 generates or
processes the various overhead bits within the DS3
frame, in the following manner.
The Frame Synchronization Overhead Bits (e.g.,
the F and M bits)
The F and M bits are always internally generated by
the Transmit Section of the XRT72L58. These over-
head bits are used (by the Remote Terminal Equip-
ment) for Frame Synchronization purposes. Hence,
the user cannot insert his/her value for the F and M
bits into the outbound DS3 data stream, via the
Transmit Overhead Data Input Interface. Any attempt
to externally insert values for the “F” and “M” bits, will
be ignored by the Transmit Overhead Data Input In-
terface"High" block.
169