XRT72L58 Datasheet, PDF (185/486 Pages) Exar Corporation – EIGHT CHANNEL DS3/E3 FRAMER IC WITH HDLC CONTROLLER

áç
EIGHT CHANNEL DS3/E3 FRAMER IC WITH HDLC CONTROLLER
PRELIMINARY
XRT72L58
REV. P1.1.2
FIGURE 53. BEHAVIOR OF THE TERMINAL INTERFACE SIGNALS BETWEEN THE XRT72L58 AND THE TERMINAL
EQUIPMENT (DS3 MODE 5 OPERATION)
Terminal Equipment Signals
TxInClk
DS3_Nib_Clock_In
DS3_Data_Out[3:0] Nibble [1175]
Tx_Start_of_Frame
Nibble [0]
XRT72L5x Transmit Payload Data I/F Signals
TxInClk
TxNibClk
TxNib[3:0]
Nibble [1175]
TxFrameRef
Nibble [0]
DS3 Frame Number N
DS3 Frame Number N + 1
Note: TxFrameRef is pulsed high to denote
first nibble within a new DS3 frame
Nibble [1]
Nibble [1]
Sampling edge of the XRT72L5x
Device
How to configure the XRT72L58 into Mode 5
1. Set the NibIntf input pin "High".
2. Set the TimRefSel[1:0] bit-fields (within the
Framer Operating Mode Register) to "01" as illus-
trated below.
FRAMER OPERATING MODE REGISTER (ADDRESS = 0X00)
BIT 7
BIT 6
BIT 5
BIT 4
BIT 3
BIT2
BIT 1
BIT 0
Local Loopback
R/W
0
DS3/E3*
R/W
0
Internal LOS
Enable
R/W
1
RESET
R/W
0
Interrupt
Enable Reset
R/W
1
Frame Format
R/W
0
TimRefSel[1:0]
R/W
R/W
0
1
3. Interface the XRT72L58, to the Terminal Equip-
ment, as illustrated in Figure 52.
4.2.1.6 Mode 6 - The Nibble-Parallel/TxInClk/
Frame-Master Interface Mode Behavior of the
XRT72L58
If the XRT72L58 has been configured to operate in
this mode, then the XRT72L58 will function as fol-
lows:
A. Local-Timed (Uses the TxInClk signal as the
Timing Reference)
In this mode, the Transmit Section of the XRT72L58
will use the TxInClk signal at its timing reference.
Further, the chip will internally divide the TxInClk
clock signal by a factor of 4 and will output this divid-
ed clock signal via the TxNibClk output pin. The
Transmit Terminal Equipment Input Interface block
(within the XRT72L58) will use the rising edge of the
166