S-7600A Datasheet, PDF (8/55 Pages) Seiko Instruments Inc – Hardware Specification (TCP/IP Network Stack LSI)

S-7600A
Hardware Specification
1.4. Trademarks
iReady iAPI^TM and iAPI^TM is a trademark of iReady Corporation. All other products and brand names
are trademarks and registered trademarks of their respective companies.
1.5. Definitions


IP
Internet Protocol


PPP Point-to-Point Protocol


TCP Transmission Control Protocol


UDP User Datagram Protocol


API Application Programming Interface
1.6. Applicable Documents


S-7600A Functional Specification


S-7600A API Application Manual
1.7. Cautions
1.
DO NOT apply a voltage or current that exceeds the absolute maximum ratings to terminals. If
applied, the IC may malfunction or be destroyed.
The standard values are set with sufficient margins, but use the IC within the recommended
operating conditions to optimize device quality.
2.
Measures against static electricity


When transporting or storing ICs, use conductive containers or metal coated boxes.



Check that there is no current leakage in electrical facilities, and be sure to ground
them. Also ensure that workbenches and people who handle ICs are grounded.

Excessive external noise to the power supply or I/O terminals of CMOS ICs causes latch-up,
leading to faults and damage. If latch-up has occurred, immediately turn off the device, eliminate
the cause, and turn on the device again.

Keep the IC away from mechanical vibration, shock, and sudden changes in temperature.
These may cause wires to break.

Environment

Use and store ICs below the absolute maximum rated temperature.


DO NOT use or store ICs where condensation can occur.

DO NOT use ICs where they are directly exposed to dust, salt, or acid gas such as
SO ₂. These may cause leaks between element leads and cause corrosion.

To store ICs for a long time, DO NOT process them. During storage, DO NOT apply
any load to ICs.
2
Seiko Instruments Inc.