LM3S2965 Datasheet, PDF (165/542 Pages) List of Unclassifed Manufacturers – Microcontroller

LM3S2965 Microcontroller
Table 9-2. GPIO Interrupt Configuration Example
Register Desired
Pin 2 Bit Value^a
Interrupt
Event
7
6
5
4
Trigger
GPIOIS
0=edge
X
X
X
X
1=level
GPIOIBE
0=single
X
X
X
X
edge
1=both
edges
GPIOIEV 0=Low level,
X
X
X
X
or negative
edge
1=High level,
or positive
edge
GPIOIM
0=masked
0
0
0
0
1=not
masked
a. X=Ignored (don’t care bit)
3
X
X
X
0
2
0
0
1
1
1
X
X
X
0
0
X
X
X
0
9.3 Register Map
“Register Map” on page 166 lists the GPIO registers. The offset listed is a hexadecimal increment
to the register’s address, relative to that GPIO port’s base address:
■ GPIO Port A: 0x4000.4000
■ GPIO Port B: 0x4000.5000
■ GPIO Port C: 0x4000.6000
■ GPIO Port D: 0x4000.7000
■ GPIO Port E: 0x4002.4000
■ GPIO Port F: 0x4002.5000
■ GPIO Port G: 0x4002.6000
■ GPIO Port H: 0x4002.7000
Important: The GPIO registers in this chapter are duplicated in each GPIO block, however,
depending on the block, all eight bits may not be connected to a GPIO pad. In those
cases, writing to those unconnected bits has no effect and reading those unconnected
bits returns no meaningful data.
Note:
The default reset value for the GPIOAFSEL, GPIOPUR, and GPIODEN registers are
0x0000.0000 for all GPIO pins, with the exception of the five JTAG/SWD pins (PB7 and
PC[3:0]). These five pins default to JTAG/SWD functionality. Because of this, the default
reset value of these registers for GPIO Port B is 0x0000.0080 while the default reset value
for Port C is 0x0000.000F.
June 04, 2007
165
Preliminary