AK4492ECB Datasheet, PDF (71/101 Pages) Asahi Kasei Microsystems – Quality Oriented 32-Bit 2ch DAC

[AK4492]
(7) Mute the analog output externally if click noise (6) adversely affect system performance.
(8) Clock inputs (MCLK, BICK and LRCK) can be stopped in power down state.
The timing example when not using the internal LDO (LODE pin = “L”) is shown in Figure 54. When the
LDOE pin= “L”, 1.8V (DVDD), 3.3V (AVDD, TVDD) and 5V (VDDL, VDDR) power supplies should be
powered up at the same time, otherwise power up 3.3V power supplies (AVDD, TVDD) first, the 1.8V
power supply (DVDD) next and 5V power supplies (VDDL/R) last.
Power
(TVDD,AVDD)
Power
(DVDD)
Power
(VDDL/R)
Analog Reference
(VREFHL/R)
PDN pin
(2)
Internal PDN
(3)
Internal State
Normal Operation (DAC Input Available)
Reset
DAC In
(Digital)
“0”data
DAC Out
(5)
(6)
(Analog)
Clock In
MCLK,LRCK,BICK
External
Mute
(1)
Don’t care
(7)
Mute ON
GD ⁽⁴⁾
“0”data
GD
(6)
(5)
(8)
(1)
Mute ON
Figure 54. Power-down/up Sequence Example (Pin Control Mode, LDOE pin=“L”)
Notes:
(1) Do not input a clock when power supplies are powered down.
(2) The PDN pin must be held “L” for more than 150ns after AVDD, TVDD, DVDD and VDDL/R
reached 90%.
(3) Internal shutdown switch is powered up after the PDN pin = “H” when the LDOE pin= “L”. The
internal circuit will start operation after the shutdown switch is ON (max. 1us).
(4) The analog output corresponding to the digital input has group delay (GD).
(5) Analog outputs are floating (Hi-Z) in power down mode.
(6) Click noise occurs at the edge of PDN signal. This noise is output even if “0” data is input.
(7) Mute the analog output externally if click noise (6) adversely affect system performance.
(8) Clock inputs (MCLK, BICK and LRCK) can be stopped in power down state.
016011073-E-00
- 71 -
2016/12