TH58NS100DC Datasheet, PDF (1/43 Pages) Toshiba Semiconductor – TOSHIBA MOS DIGITAL INTEGRATED CIRCUIT SILICON GATE CMOS 1 - GBIT (128M X 8 BITS) CMOS NAND E2PROM ( 128M BYTE SmartMediaTM )

TH58NS100DC
TENTATIVE TOSHIBA MOS DIGITAL INTEGRATED CIRCUIT SILICON GATE CMOS
1-GBIT (128M ´ 8 BITS) CMOS NAND E²PROM (128M BYTE SmartMedia^TM)
DESCRIPTION
The TH58NS100 is a single 3.3-V 1-Gbit (1,107,296,256) bit NAND Electrically Erasable and Programmable
Read-Only Memory (NAND E²PROM) organized as 528 bytes ´ 32 pages ´ 8192 blocks. The device has a 528-byte
static register which allows program and read data to be transferred between the register and the memory cell
array in 528-byte increments. The Erase operation is implemented in a single block unit (16 Kbytes + 512 bytes:
528 bytes ´ 32 pages).
The TH58NS100 is a serial-type memory device which utilizes the I/O pins for both address and data
input/output as well as for command inputs. The Erase and Program operations are automatically executed.
The TH58NS100DC is a SmartMedia^TM with ID and each device has 128 bit unique ID number embedded in the
device. This unique ID number is applicable to image files, music files, electronic books, and so on where copyright
protection is required.
The data stored in the TH58NS100DC needs to comply with the data format standardized by the SSFDC Forum
in order to maintain compatibility with other SmartMedia^TM systems.
FEATURES
· Organization
Memory cell array 528 ´ 128K ´ 8 ´ 2
Register
528 ´ 8
Page size
528 bytes
Block size
(16K + 512) bytes
· Modes
Read, Reset, Auto Page Program,
Auto Block Erase, Status Read
· Mode control
Serial input/output, Command control
· Complies with the SmartMedia^TM Electrical
Specification and Data Format Specification
issued by the SSFDC Forum
· Power supply
VCC = 3.3 V ± 0.3 V
· Program/Erase Cycles 1E5 cycle (with ECC)
· Access time
Cell array-register
25 ms max
Serial Read cycle
50 ns min
· Operating current
Read (50-ns cycle)
10 mA typ.
Program (avg.)
10 mA typ.
Erase (avg.)
10 mA typ.
Standby
100 mA max
· Package
FDC-22C (Weight: 2.2 g typ.)
PIN ASSIGNMENT (TOP VIEW)
PIN NAMES
V_SS CLE ALE WE WP I/O1 I/O2 I/O3 I/O4 V_SS V_SS
1 2 3 4 5 6 7 8 9 10 11
22 21 20 19 18 17 16 15 14 13 12
I/O1 to I/O8
CE
WE
RE
CLE
ALE
WP
RY/BY
GND
LVD
V_CC
V_SS
I/O port
Chip enable
Write enable
Read enable
Command latch enable
Address latch enable
Write protect
Ready/Busy
Ground Input
Low Voltage Detect
Power supply
Ground
V_CC CE RE RY/BY GND LVD I/O8 I/O7 I/O6 I/O5 V_CC
TM
is a trademark of Toshiba Corporation.
000707EBA2
· TOSHIBA is continually working to improve the quality and reliability of its products. Nevertheless, semiconductor devices in general
can malfunction or fail due to their inherent electrical sensitivity and vulnerability to physical stress. It is the responsibility of the
buyer, when utilizing TOSHIBA products, to comply with the standards of safety in making a safe design for the entire system, and
to avoid situations in which a malfunction or failure of such TOSHIBA products could cause loss of human life, bodily injury or
damage to property.
In developing your designs, please ensure that TOSHIBA products are used within specified operating ranges as set forth in the
most recent TOSHIBA products specifications. Also, please keep in mind the precautions and conditions set forth in the “Handling
Guide for Semiconductor Devices,” or “TOSHIBA Semiconductor Reliability Handbook” etc..
· The TOSHIBA products listed in this document are intended for usage in general electronics applications (computer, personal
equipment, office equipment, measuring equipment, industrial robotics, domestic appliances, etc.). These TOSHIBA products are
neither intended nor warranted for usage in equipment that requires extraordinarily high quality and/or reliability or a malfunction or
failure of which may cause loss of human life or bodily injury (“Unintended Usage”). Unintended Usage include atomic energy
control instruments, airplane or spaceship instruments, transportation instruments, traffic signal instruments, combustion control
instruments, medical instruments, all types of safety devices, etc.. Unintended Usage of TOSHIBA products listed in this document
shall be made at the customer’s own risk.
2001-03-21 1/43