TL16C750 Datasheet, PDF (9/35 Pages) Texas Instruments – ASYNCHRONOUS COMMUNICATIONS ELEMENT WITH 64-BYTE FIFOs AND AUTOFLOW CONTROL

TL16C750
ASYNCHRONOUS COMMUNICATIONS ELEMENT
WITH 64-BYTE FIFOs AND AUTOFLOW CONTROL
SLLS191C – JANUARY 1995 – REVISED DECEMBER 1997
electrical characteristics over recommended ranges of supply voltage and operating free-air
temperature (unless otherwise noted)
low voltage (3.3 V nominal)
PARAMETER
TEST CONDITIONS
VOH
VOL
High-level output voltage†
Low-level output voltage†
IOH = – 1.8 mA
IOL = 3.2 mA
IOZ High-impedance 3-state output current (see Note 6)
VI = VCC or GND
IIL
Low-level input current (see Note 7)
VI = GND
IIH High-level input current (see Note 8)
VI = VCC
† _{For all outputs except XOUT}
NOTES: 6. The 3-state or open-drain output must be in the high-impedance state.
7. Specifications only apply with pullup termination turned off.
8. Specifications only apply with pulldown termination turned off.
standard voltage (5 V nominal)
PARAMETER
TEST CONDITIONS
VOH
VOL
High-level output voltage†
Low-level output voltage†
IOH = – 4 mA
IOL = 4 mA
IOZ High-impedance 3-state output current (see Note 6)
VI = VCC or GND
IIL
Low-level input current (see Note 7)
VI = GND
IIH High-level input current (see Note 8)
VI = VCC
† _{For all outputs except XOUT}
NOTES: 6. The 3-state or open-drain output must be in the high-impedance state.
7. Specifications only apply with pullup termination turned off.
8. Specifications only apply with pulldown termination turned off.
MIN
VCC – 0.55
MAX
0.5
± 10
–1
1
UNIT
V
V
µA
µA
µA
MIN
VCC – 0.8
MAX
0.5
± 10
–1
1
UNIT
V
V
µA
µA
µA
• POST OFFICE BOX 655303 DALLAS, TEXAS 75265
9