GC5016 Datasheet, PDF (55/88 Pages) Texas Instruments – WIDEBAND QUAD DIGITAL DOWN CONVERTER/ UP CONVERTER

www.ti.com
CEÓÓÓÓÓÓÓÓ
tREC
WRÓÓÓÓÓÓÓÓ
tsu(C)
RD^{ÓÓÓÓÓÓÓÓÓÓÓÓ}
GC5016
SLWS142G − JANUARY 2003 − REVISED NOVEMBER 2005
ÔÔÔÔÔÔ
ÔÔÔÔÔÔÔÔ
tCSPW
ÔÔÔÔÔÔÔÔÔÔÔÔ
A [4:0]
th(C)
C [15:0]
WRITE CYCLE − NORMAL MODE
Figure 28. Dual Strobe Edge Mode Write Timing
tsu(EWC)
16.3 Single Strobe, Edge Mode(WRMODE = 0), Control Bus Timing
(See Figures 29 and 30)
Some processors provide a single control RD/WR together with a chip strobe that controls timing. In this case, the
RD pin can be grounded. The control processor must set A[4..0] to the desired register address, set WR low for a
write or high for a read, and select the chip by setting CE low. The write cycle is active while both CE and WR are
low. Data on the C[15..0] is registered into the chip on the rising edge of CE.
55