LSM9DS1 Datasheet, PDF (47/72 Pages) –

LSM9DS1
Accelerometer and gyroscope register description
7.13
CTRL_REG2_G (11h)
Angular rate sensor Control Register 2.
Table 48. CTRL_REG2_G register
0⁽¹⁾
0⁽¹⁾
0⁽¹⁾
0⁽¹⁾ INT_SEL1 INT_SEL0 OUT_SEL1 OUT_SEL0
1. These bits must be set to ‘0’ for the correct operation of the device
INT_SEL [1:0]
Table 49. CTRL_REG2_G register description
INT selection configuration. Default value: 00
(Refer to Figure 28)
OUT_SEL [1:0]
Out selection configuration. Default value: 00
(Refer to Figure 28)
Figure 28. INT_SEL and OUT_SEL configuration gyroscope block diagram
$'& /3)
+3)
/3)
'DWD5HJ
),)2
,QWHUUXSW
JHQHUDWRU
7.14
CTRL_REG3_G (12h)
Angular rate sensor Control Register 3.
LP_mode HP_EN
Table 50. CTRL_REG3_G register
0⁽¹⁾
0⁽¹⁾ HPCF3_G HPCF2_G HPCF1_G HPCF0_G
1. These bits must be set to ‘0’ for the correct operation of the device
LP_mode
Table 51. CTRL_REG3_G register description
Low-power mode enable. Default value: 0
(0: Low-power disabled; 1: Low-power enabled)
HP_EN
High-pass filter enable. Default value: 0
(0: HPF disabled; 1: HPF enabled, refer to Figure 28)
HPCF_G [3:0]
Gyroscope high-pass filter cutoff frequency selection. Default value: 0000
Refer to Table 52.
DocID025715 Rev 3
47/72
72