M16C62_N Datasheet, PDF (618/621 Pages) Renesas Technology Corp – 16-BIT SINGLE-CHIP MICROCOMPUTER M16C FAMILY

Mitsubishi microcomputers
M16C / 62 Group
SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER
Version
Contents for change
REV.C Page 463 Figure 3.2.4 Setting One-shot timer's time
3F16 --> 4016.
Revision
date
99.12.1
Page 465 Figure 3.3.1
000016 --> 000116.
Page 559 to 562 Figure 7.1.5, Figure 7.1.6, Figure 7.2.1 and Figure 7.2.2
All changed
Page 560
Add to Figure 7.1.7
Page 567 to 601
Add to Appendix.
REV.C1
Page 151 Note 2
• Before data can be written to the SI/Oi transmit/receive register (addresses
036016, 036416), the CLKi pin input must be in the low state. Also, before rewriting
the SI/Oi Control Register (addresses 036216, 036616)’s bit 7 (SOUTi initial value
set bit), make sure the CLKi pin input is held low. ---> • Before data can be written
to the SI/Oi transmit/receive register (addresses 036016, 036416), the CLKi pin
input must be in the high state. Also, before rewriting the SI/Oi Control Register
(addresses 036216, 036616)’s bit 7 (SOUTi initial value set bit), make sure the CLKi
pin input is held high.
REV.C2
Page 35, Table 1.12.2
_______
Normal mode, microprocessor mode, CS0 area
0300016 to FFFFF16 --->3000016 to FFFFF16
_______
Expansion mode 1, microprocessor mode, PM13=1, CS0 area
0600016 to FFFFF16 --->0600016 to BFFFF16
99.12.21
00.7.4
Page 50, Figure 1.13.6
Note: Writing a value to an address after “1” is written to this bit returns the bit to
“0” . Other bits do not automatically return to “0” and they must therefore
be reset by the program.
Page 150, Figure 1.19.32, bit 5 of the SI/Oi control register (i=3, 4)
Transfer direction lect bit --->Transfer direction select bit
Page 150, Figure 1.19.32, Note 2
When using the port as an input/output port by setting the SI/Oi port select bit (i =
3, 4) to “1”, be sure to set the sync clock select bit to “1”.
--->
When using the port as an input/output port by setting the SI/Oi port select bit (i =
3, 4) to “0”, be sure to set the sync clock select bit to “1”.
Revision history
M16C/62 User's Manual
603