M16C62_N Datasheet, PDF (314/621 Pages) Renesas Technology Corp – 16-BIT SINGLE-CHIP MICROCOMPUTER M16C FAMILY

Timer A
Mitsubishi microcomputers
M16C / 62 Group
SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER
Selecting event counter mode and functions
b7
b0 _{Timer Ai mode register (i= 3, 4) [Address 039916, 039A16]}
1 1 0 1 0 0 0 1 _{TAiMR (i= 3, 4)}
Selection of event counter mode
0 (Must always be “0” when using two-phase pulse signal processing)
0 (Must always be “0” when using two-phase pulse signal processing)
1 (Must always be “1” when using two-phase pulse signal processing)
0 (Must always be “0” when using two-phase pulse signal processing)
Count operation type select bit
1 : Free-run type
Two-phase pulse signal processing operation select bit
1 : Multiply-by-4 processing operation
Two-phase pulse signal processing select bit
b7
b0 _{Up/down flag [address 038416]}
UDF
Timer A3 two-phase pulse signal processing select bit
1 : Two-phase pulse signal processing enabled
Timer A4 two-phase pulse signal processing select bit
1 : Two-phase pulse signal processing enabled
Setting divide ratio
(b15)
b7
(b8)
b0 b7
b0 _{Timer A3 register [Address 038D16, 038C16] TA3}
Timer A4 register [Address 038F16, 038E16] TA4
Can be set to 000016 to FFFF16
Setting count start flag
b7
b0
Count start flag [Address 038016]
TABSR
Timer A3 count start flag
Timer A4 count start flag
Start count
Figure 2.2.19. Set-up procedure of 2-phase pulse signal process in event counter mode, multiply-by-4 mode selected
299