|
M16C62_N Datasheet, PDF (195/621 Pages) Renesas Technology Corp – 16-BIT SINGLE-CHIP MICROCOMPUTER M16C FAMILY | |||
|
◁ |
Usage precaution
Mitsubishi microcomputers
M16C / 62 Group
SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER
External ROM version
The external ROM version is operated only in microprocessor mode, so be sure to perform the following:
⢠Connect CNVss pin to Vcc.
⢠Fix the processor mode bit to â112â
Built-in PROM version
(1) All built-in PROM versions
High voltage is required to program to the built-in PROM. Be careful not to apply excessive voltage.
Be especially careful during power-on.
(2) One Time PROM version
One Time PROM versions shipped in blank (M30620ECFP, M30620ECGP), of which built-in PROMs
are programmed by users, are also provided. For these microcomputers, a programming test and
screening are not performed in the assembly process and the following processes. Therefore ROM
write defectiveness occurs around 5 %. To improve their reliability after programming, we recommend
to program and test as flow shown in Figure 1.24.1 before use.
Programming with PROM programmer
Screening (Note)
(Leave at 150ËC for 40 hours)
Verify test PROM programmer
Function check in target device
Note: Never expose to 150ËC exceeding 100 hours.
Figure 1.24.1. Programming and test flow for One Time PROM version
(3) EPROM version
⢠Cover the transparent glass window with a shield or others during the read mode because exposing
to sun light or fluorescent lamp can cause erasing the information.
A shield to cover the transparent window is available from Mitsubishi Electric Corp. Be careful that
the shield does not touch the EPROM lead pins.
⢠Clean the transparent glass before erasing. Fingersâ flat and paste disturb the passage of ultraviolet
rays and may affect badly the erasure capability.
⢠The EPROM version is a tool only for program development (for evaluation), and do not use it for the
mass product run.
180
|
▷ |