S128 Datasheet, PDF (47/107 Pages) Renesas Technology Corp – Microcontroller

S128
2. Electrical Characteristics
Table 2.13 Operating and standby current (3)
Conditions: VCC = AVCC0 = 1.6 to 5.5 V
Parameter
Symbol Min Typ
Test
Max Unit conditions
Operational
Amplifier
operating
current
Low power mode
1-unit operating
2-unit operating
3-unit operating
I_AMP
-
1.0
-
1.5
-
2.0
2.0
μA
-
3.0
μA
-
3.5
μA
-
4-unit operating
-
2.5
4.5
μA
-
High speed mode
1-unit operating
-
200
280
μA
-
2-unit operating
-
320
450
μA
-
3-unit operating
-
440
620
μA
-
4-unit operating
-
560
790
μA
-
USB operating
current
During USB communication under the following
settings and conditions:
I_USBF*²
-
 Function controller is in Full-Speed mode and
- Bulk OUT transfer is (64 bytes) × 1
- Bulk IN transfer is (64 bytes) × 1
 Host device is connected by a 1-meter USB cable
from the USB port.
3.6 (VCC)
-
1.1 (VCC_USB)*⁴
mA
-
During suspended state under the following setting
and conditions:
I_SUSP*³
-
 Function controller is in Full-Speed mode (the
USB_DP pin is pulled up)
 Software Standby mode
 Host device is connected by a 1-meter USB cable
from the USB port.
0.35 (VCC)
-
170 (VCC_USB)*⁴
μA
-
PWM Delay
Generation
Circuit current
PCLKD = 64 MHz, DLL Mode = 5-bit mode
PCLKD = 64 MHz, DLL Mode = 4-bit mode
PCLKD = 32 MHz, DLL Mode = 5-bit mode
I_CC
-
3.3
-
3.0
-
2.0
4.6
mA
-
4.2
mA
-
2.8
mA
-
Note 1. The reference power supply current is included in the power supply current value for D/A conversion.
Note 2. Current is consumed only by the USBFS.
Note 3. Includes the current supplied from the pull-up resistor of the USB_DP pin to the pull-down resistor of the host
device, in addition to the current consumed by the MCU in the suspended state.
Note 4. When VCC = VCC_USB = 3.3 V.
Note 5. When the MCU is in Software Standby mode or the MSTPCRD.MSTPD16 (ADC140 module-stop bit) is in the
module-stop state.
R01DS0309EU0100 Rev.1.00
Mar 10, 2017
Page 47 of 107