English
Language : 

MC68HC05C8A Datasheet, PDF (81/158 Pages) Motorola, Inc – Microcontrollers
Serial Communications Interface (SCI)
SCI Input/Output (I/O) Registers
ILIE — Idle Line Interrupt Enable Bit
This read/write bit enables SCI interrupt requests when the IDLE bit
becomes set. Reset clears the ILIE bit.
1 = IDLE interrupt requests enabled
0 = IDLE interrupt requests disabled
TE — Transmit Enable Bit
Setting this read/write bit begins the transmission by sending a
preamble of 10 or 11 logic 1s from the transmit shift register to the
PD1/TDO pin. Reset clears the TE bit.
1 = Transmission enabled
0 = Transmission disabled
RE — Receive Enable Bit
Setting this read/write bit enables the receiver. Clearing the RE bit
disables the receiver and receiver interrupts but does not affect the
receiver interrupt flags. Reset clears the RE bit.
1 = Receiver enabled
0 = Receiver disabled
RWU — Receiver Wakeup Enable Bit
This read/write bit puts the receiver in a standby state. Typically, data
transmitted to the receiver clears the RWU bit and returns the receiver
to normal operation. The WAKE bit in SCCR1 determines whether an
idle input or an address mark brings the receiver out of the standby
state. Reset clears the RWU bit.
1 = Standby state
0 = Normal operation
SBK — Send Break Bit
Setting this read/write bit continuously transmits break codes in the
form of 10-bit or 11-bit groups of logic 0s. Clearing the SBK bit stops
the break codes and transmits a logic 1 as a start bit. Reset clears the
SBK bit.
1 = Break codes being transmitted
0 = No break codes being transmitted
MC68HC05C8A • MC68HCL05C8A • MC68HSC05C8A — Rev. 5.0
MOTOROLA
Serial Communications Interface (SCI)
Technical Data
81