M37280MF Datasheet, PDF (99/178 Pages) Mitsubishi Electric Semiconductor – SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER with CLOSED CAPTION DECODER and ON-SCREEN DISPLAY CONTROLLER

PRELIMINARY _{NSootimcee: pTahriasmisennotitcalimfinitasl} ^{asrpeecsiufibcjaetciot nto. change.}
MITSUBISHI MICROCOMPUTERS
M37280MF–XXXSP, M37280MK–XXXSP
M37280EKSP
SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER with CLOSED CAPTION DECODER
and ON-SCREEN DISPLAY CONTROLLER
(4) Border
The border is output only in the OSD mode. The all bordered
(bordering around of character font) and the shadow bordered
(bordering right and bottom sides of character font) are selected
(refer to Figure 12.11.31) by bit 2 of the OSD control register 1
(refer to Figure 12.11.3). The ON/OFF switch for borders can be
controlled in block units by bit 2 of the block control register i
(refer to Figure 12.11.4).
The OUT1 signal is used for border output. The border color is
fixed at color code 8 (block). The border color for each screen is
specified by the border color register i.
The horizontal size (x) of border is 1TC (OSD clock cycle divided
in the pre-divide circuit) regardless of the character font dot size.
However, only when the pre-divide ratio = 2 and character size =
1.5TC, the horizontal size is 1.5TC. The vertical size (y) different
depending on the screen scan mode and the vertical dot size of
character font.
Notes 1: T h e b o r d e r d o t a r e a i s t h e s h a d e d a r e a a s s h o w n i n
Figure 12.11.34.
2: When the border dot overlaps on the next character font, the charac-
ter font has priority (refer to Figure 12.11.35 A). When the border dot
overlaps on the next character back ground, the border has priority
(refer to Figure 12.11.35 B).
3: The border in vertical out of character area is not displayed (refer to
Figure 12.11.35).
All bordered
Fig. 12.11.32 Example of Border Display
Shadow bordered
y
Border
dot size
x
Scan mode
Vertical dot size of
character font
Horizontal size (x)
Vertical size (y)
Normal scan mode
Bi-scan mode
1/2H
1H, 2H, 3H
1/2H, 1H, 2H, 3H
1TC (OSD clock cycle divided in pre-divide circuit)
1.5TC when selecting 1.5TC for character size.
1/2H
1H
1H
Fig. 12.11.33 Horizontal and Vertical Size of Border
Rev. 1.0
99