M37280MF Datasheet, PDF (12/178 Pages) Mitsubishi Electric Semiconductor – SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER with CLOSED CAPTION DECODER and ON-SCREEN DISPLAY CONTROLLER

PRELIMINARY _{NSootimcee: pTahriasmisennotitcalimfinitasl} ^{asrpeecsiufibcjaetciot nto. change.}
MITSUBISHI MICROCOMPUTERS
M37280MF–XXXSP, M37280MK–XXXSP
M37280EKSP
SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER with CLOSED CAPTION DECODER
and ON-SCREEN DISPLAY CONTROLLER
12. FUNCTIONAL DESCRIPTION
12.1. CENTRAL PROCESSING UNIT (CPU)
This microcomputer uses the standard 740 Family instruction set.
Refer to the table of 740 Family addressing modes and machine
instructions or the SERIES 740 <Software> User’s Manual for de-
tails on the instruction set.
Machine-resident 740 Family instructions are as follows:
The FST, SLW instruction cannot be used.
The MUL, DIV, WIT and STP instructions can be used.
12.1.1 CPU Mode Register
The CPU mode register contains the stack page selection bit and
internal system clock selection bit. The CPU mode register is allo-
cated at address 00FB16.
CPU Mode Register
b7 b6 b5 b4 b3 b2 b1 b0
1 1 0 0 CPU mode register (CM) [Address 00FB16]
B
Name
0, 1 Processor mode bits
(CM0, CM1)
2 Stack page selection
bit (CM2) (See note)
Functions
After reset R W
b1 b0
0 0: Single-chip mode
0 RW
0 1:
1 0: Not available
1 1:
0: 0 page
1: 1 page
1 RW
3, 4 Fix these bits to “1.”
1 RW
5 ^{XCOUT drivability}
selection bit (CM5)
0: LOW drive
1: HIGH drive
6 ^{Main Clock (XIN–XOUT)} 0: Oscillating
stop bit
1: Stopped
(CM6)
7 Internal system clock 0: XIN–XOUT selected
selection bit
(high-speed mode)
(CM7)
1: XCIN–XCOUT selected
(low-speed mode)
Note: This bit is set to “1” after the reset release.
1 RW
0 RW
0 RW
Fig. 12.1.1 CPU Mode Register
Rev. 1.0
12