|
PIC18F4550-IP Datasheet, PDF (3/438 Pages) Microchip Technology – 28/40/44-Pin, High-Performance, Enhanced Flash, USB Microcontrollers with nanoWatt Technology | |||
|
◁ |
PIC18F2455/2550/4455/4550
28/40/44-Pin, High-Performance, Enhanced Flash,
USB Microcontrollers with nanoWatt Technology
Universal Serial Bus Features:
⢠USB V2.0 Compliant
⢠Low Speed (1.5 Mb/s) and Full Speed (12 Mb/s)
⢠Supports Control, Interrupt, Isochronous and Bulk
Transfers
⢠Supports up to 32 Endpoints (16 bidirectional)
⢠1 Kbyte Dual Access RAM for USB
⢠On-Chip USB Transceiver with On-Chip Voltage
Regulator
⢠Interface for Off-Chip USB Transceiver
⢠Streaming Parallel Port (SPP) for USB streaming
transfers (40/44-pin devices only)
Power-Managed Modes:
⢠Run: CPU on, Peripherals on
⢠Idle: CPU off, Peripherals on
⢠Sleep: CPU off, Peripherals off
⢠Idle mode Currents Down to 5.8 μA Typical
⢠Sleep mode Currents Down to 0.1 μA Typical
⢠Timer1 Oscillator: 1.1 μA Typical, 32 kHz, 2V
⢠Watchdog Timer: 2.1 μA Typical
⢠Two-Speed Oscillator Start-up
Flexible Oscillator Structure:
⢠Four Crystal modes, including High-Precision PLL
for USB
⢠Two External Clock modes, Up to 48 MHz
⢠Internal Oscillator Block:
- 8 user-selectable frequencies, from 31 kHz
to 8 MHz
- User-tunable to compensate for frequency drift
⢠Secondary Oscillator using Timer1 @ 32 kHz
⢠Dual Oscillator Options allow Microcontroller and
USB module to Run at Different Clock Speeds
⢠Fail-Safe Clock Monitor:
- Allows for safe shutdown if any clock stops
Peripheral Highlights:
⢠High-Current Sink/Source: 25 mA/25 mA
⢠Three External Interrupts
⢠Four Timer modules (Timer0 to Timer3)
⢠Up to 2 Capture/Compare/PWM (CCP) modules:
- Capture is 16-bit, max. resolution 5.2 ns (TCY/16)
- Compare is 16-bit, max. resolution 83.3 ns (TCY)
- PWM output: PWM resolution is 1 to 10-bit
⢠Enhanced Capture/Compare/PWM (ECCP) module:
- Multiple output modes
- Selectable polarity
- Programmable dead time
- Auto-shutdown and auto-restart
⢠Enhanced USART module:
- LIN bus support
⢠Master Synchronous Serial Port (MSSP) module
Supporting 3-Wire SPI (all 4 modes) and I2Câ¢
Master and Slave modes
⢠10-Bit, Up to 13-Channel Analog-to-Digital Converter
(A/D) module with Programmable Acquisition Time
⢠Dual Analog Comparators with Input Multiplexing
Special Microcontroller Features:
⢠C Compiler Optimized Architecture with Optional
Extended Instruction Set
⢠100,000 Erase/Write Cycle Enhanced Flash
Program Memory Typical
⢠1,000,000 Erase/Write Cycle Data EEPROM
Memory Typical
⢠Flash/Data EEPROM Retention: > 40 Years
⢠Self-Programmable under Software Control
⢠Priority Levels for Interrupts
⢠8 x 8 Single-Cycle Hardware Multiplier
⢠Extended Watchdog Timer (WDT):
- Programmable period from 41 ms to 131s
⢠Programmable Code Protection
⢠Single-Supply 5V In-Circuit Serial
Programming⢠(ICSPâ¢) via Two Pins
⢠In-Circuit Debug (ICD) via Two Pins
⢠Optional Dedicated ICD/ICSP Port (44-pin, TQFP
package only)
⢠Wide Operating Voltage Range (2.0V to 5.5V)
Device
Program Memory
Data Memory
Flash
# Single-Word
SRAM
EEPROM
I/O
10-Bit CCP/ECCP
A/D (ch) (PWM)
SPP
(bytes) Instructions (bytes) (bytes)
MSSP
SPI
Master
I2Câ¢
Timers
8/16-Bit
PIC18F2455 24K
PIC18F2550 32K
PIC18F4455 24K
PIC18F4550 32K
12288
16384
12288
16384
2048
256
24 10
2048
256
24 10
2048
256
35 13
2048
256
35 13
2/0
No Y
Y
1 2 1/3
2/0
No Y
Y
1 2 1/3
1/1
Yes Y
Y
1 2 1/3
1/1
Yes Y
Y
1 2 1/3
© 2009 Microchip Technology Inc.
DS39632E-page 1
|
▷ |