English
Language : 

TLE9263-3QX Datasheet, PDF (96/198 Pages) Infineon Technologies AG – Dedicated Data Sheets are available for the different product variants
TLE9263-3QX
LIN Transceiver
11.2.4 LIN Wake Capable Mode
This mode can be used in SBC Stop, Sleep, Restart and Normal Mode by programming via SPI and it is used to
monitor bus activities. It is automatically accessed in SBC Fail-Safe Mode. A wake-up signal on the bus (filter time
t > tWK,Bus) results in different behavior of the SBC, as described in below Table 25. As a signalization to the
microcontroller, the RXD_LIN pin is set LOW and will stay LOW until the LIN transceiver is changed to any other
mode. After a wake-up event the transceiver can be switched to LIN Normal Mode for communication.
Rearming the transceiver for wake capability
After a BUS wake-up event, the transceiver is woken. However, the LIN1 and LIN2 transceiver mode bits will still
show wake capable (=‘01’) so that the RXD signal will be pulled low. There are two possibilities how the LIN
transceiver’s wake capable mode is enabled again after a wake event:
• The LIN transceiver mode must be toggled, i.e. switched to LIN Normal Mode, LIN Receive Only Mode or LIN
Off, before switching to LIN Wake Capable Mode again.
• Rearming is done automatically when the SBC is changed to SBC Stop, SBC Sleep, or SBC Fail-Safe Mode
to ensure wake-up capability.
Wake-Up in SBC Stop and SBC Normal Mode
In SBC Stop Mode, if a wake-up is detected, it is signaled by the INT output and in the WK_STAT_1 SPI register.
It is also signaled by RXDLIN put to LOW. The same applies for the SBC Normal Mode. The microcontroller should
set the device to SBC Normal Mode, there is no automatic transition to Normal Mode.
For functional safety reasons, the watchdog will be automatically enabled in SBC Stop Mode after a Bus wake
event in case it was disabled before (if bit WD_EN_ WK_BUS was configured to HIGH before).
Wake-Up in SBC Sleep Mode
Wake-up is possible via a LIN message (filter time t > tWK,Bus). The wake-up automatically transfers the SBC into
the SBC Restart Mode and from there to Normal Mode the corresponding RXD pin in set to LOW. The
microcontroller is able to detect the low signal on RXD and to read the wake source out of the WK_STAT_1
register via SPI. No interrupt is generated when coming out of Sleep Mode. The microcontroller can now switch
the LIN transceiver into LIN Normal Mode via SPI to start communication.
Table 25 Action due to a LIN BUS Wake-up
SBC Mode
SBC Mode after Wake
Normal Mode
Normal Mode
Stop Mode
Stop Mode
Sleep Mode
Restart Mode
Restart Mode
Restart Mode
Fail-Safe Mode
Restart Mode
VCC1
ON
ON
Ramping Up
ON
Ramping up
INT
LOW
LOW
HIGH
HIGH
HIGH
RXD
LOW
LOW
LOW
LOW
LOW
Data Sheet
96
Rev. 1.1, 2014-09-26