TLE9263-3QX Datasheet, PDF (190/198 Pages) Infineon Technologies AG – Dedicated Data Sheets are available for the different product variants

TLE9263-3QX
Application Information
Note: Unused outputs are recommended to be left unconnected on the application board. If unused output pins
are routed to an external connector which leaves the ECU, then these pins should have provision for a zero
ohm jumper (depopulated if unused) or ESD protection.
Table 39 Bill of Material for Simplified Application Diagram
Ref. Typical Value
Purpose / Comment
Capacitances
C1
68µF
Buffering capacitor to cut off battery spikes, depending on application
C2
100nF
EMC, blocking capacitor
C3
22µF
Buffering capacitor to cut off battery spikes from VSHS as separate supply
input; Depending on application, only needed if VSHS is not connected to
VS;
C4
2.2µF low ESR
As required by application, min. 470nF for stability
C5
100nF ceramic
Spike filtering, improve stability of supply for microcontroller;
not needed for SBC
C6
2.2µF low ESR
Blocking capacitor, min. 470nF for stability;
if used for CAN supply place a 100nF ceramic capacitor in addition very
close to VCAN pin for optimum EMC behavior
C7
33nF
As required by application, mandatory protection for off-board connections
C8
33nF
As required by application, mandatory protection for off-board connections
C17 47pF
Only required in case of off-board connection to optimize EMC behavior,
place close to pin
C18 47pF
Only required in case of off-board connection to optimize EMC behavior,
place close to pin
C9
10nF
Spike filtering, as required by application, mandatory protection for off-board
connections (see also Simplified Application Diagram with the Alternate
Measurement Function)
C10 10nF
Spike filtering, as required by application, mandatory protection for off-board
connections
C11 10nF
Spike filtering, as required by application, mandatory protection for off-board
connections
C12 4.7nF / OEM dependent Split termination stability
C13 10µF low ESR
Stability of VCC3, e.g. Murata 10 µF/10 V GCM31CR71A106K64L
C14 47nF
Only required in case of off-board connection to optimize EMC behavior,
place close to connector
C15 1nF / OEM dependent LIN master termination
C16 1nF / OEM dependent LIN master termination
Resistances
R1
10kΩ
Wetting current of the switch, as required by application
R2
10kΩ
Limit the WK pin current, e.g. for ISO pulses
R3
10kΩ
Wetting current of the switch, as required by application
R4
10kΩ
Limit the WK pin current, e.g. for ISO pulses
R5
10kΩ
Wetting current of the switch, as required by application
R6
10kΩ
Limit the WK pin current, e.g. for ISO pulses
Data Sheet
190
Rev. 1.1, 2014-09-26