English
Language : 

TLE9263-3QX Datasheet, PDF (167/198 Pages) Infineon Technologies AG – Dedicated Data Sheets are available for the different product variants
TLE9263-3QX
Serial Peripheral Interface
16.5.3 Selective Wake Trimming and Calibration Control Registers
SWK_OSC_TRIM_CTRL
SWK Oscillator Trimming Register (Address 011 1000B)
POR / Soft Reset Value: xxxx xxxxB; Restart Value: xxxx xxxxB
7
6
5
4
3
2
1
0
TRIM_OSC_7 TRIM_OSC_6 TRIM_OSC_5 TRIM_OSC_4 TRIM_OSC_3 TRIM_OSC_2 TRIM_OSC_1 TRIM_OSC_0
r
rw
rw
rw
rw
rw
rw
rw
rw
Field
Bits
TRIM_OSC 7:0
Type
rw
Description
Oscillator trimming (bit0=LSB; bit7=MSB);
(only writable if TRIM_EN = ‘11’)
Note: TRIM_OSC[0:4] represent the 32-steps fine trimming range with a monotonous behavior from slower to
faster frequency. The step width is ~0.25MHz.
TRIM_OSC[5:7] are modifying the oscillator temperature coefficient. It is strongly recommended to not
change these values.
Due to CDR functionality, it is not required to change these values.
SWK_OPT_CTRL
Selective Wake Options Register (Address 011 1001B)
POR / Soft Reset Value: 000x xxxxB; Restart Value: x00x xxxxB
7
6
5
4
3
2
1
0
RX_WK_SEL Reserved
rw
r
Reserved
rw
TRIM_OSC_1
2
TRIM_OSC_1
1
TRIM_OSC_1
0
TRIM_OSC_9
TRIM_OSC_8
r
rw
rw
rw
rw
rw
Field
Bits
RX_WK_ 7
SEL
Reserved 6:5
TRIM_OSC 4:0
Type
rw
r
rw
Description
SWK Receiver selection (only accessible if TRIM_EN = ‘11’)
0B , Standard Receiver selected during SWK
1B , Low-Power Receiver selected during SWK
Reserved, always reads as 0
Oscillator trimming (bit8=LSB; bit12=MSB);
(only writable if TRIM_EN = ‘11’)
Note: The bit RX_WK_SEL is used to select the respective receiver during Selective Wake operation. To reduce
the quiescent current during Frame Detect Mode it is recommended to select the Low-Power Receiver, i.e.
RX_WK_SEL = ‘1’
Note: TRIM_OSC[8:12] represent the 32-steps coarse trimming range, which is not monotonous.
It is not recommended to change these values.
Data Sheet
167
Rev. 1.1, 2014-09-26