TC11IB Datasheet, PDF (74/108 Pages) Infineon Technologies AG – 32-Bit Single-Chip Microcontroller

TC11IB
DC-Characteristics(cont’d)
V_SS = 0 V; T_A = -25 °C to +85 °C
Parameter
Symbol
Limit Values
IDSEL pin capacitance ⁹⁾
Pin inductance
min.
C_IDSELCC –
L_PIN CC –
max.
8
20
Unit Test Condition
pF
nH
Oscillator Pins
Input low voltage at XTAL1 V_ILX SR
-0.3 0.3 ×
V
V_DDOSC
Input high voltage at XTAL1 V_IHX SR 0.7 ×
2.4
V
V_DDOSC
Notes:
1) _{The current is applicable to the pins, for which a pull up has been specified. Refer to Table 1. IPUx refers to the}
pull up current for type x.
2) _{The current is applicable to the pins, for which a pull down has been specified. Refer to Table 1. IPDx refers to}
the pull down current for type x.
3) _{Pins with internal pull up or pull down are not included.}
4) _{Not 100% tested, guaranteed by design characterization.}
5) _{This specification is guaranteed by design. It is the minimum voltage to which pull up resistors are calculated}
to pull a floated network. Applications sensitive to static power utilization must assure that the input buffer is
conducting minimum current at this input voltage.
6) _{Input leakage currents include high impedance output leakage for all bi-directional buffers with tristate outputs.}
7) _{This input leakage is the maximum allowable leakage into the PME open drain driver when power is removed}
from VDD of the component. This assumes that no event has occurred to cause the device to attempt to assert
PME.
8) _{Absolute maximum pin capacitance for a PCI input is 10pF (except for CLK). Exceptions are granted to}
motherboard-only devices up to 16pF.
9) _{Lower capacitance on this input-only pin allows for non-resistive coupling to AD[xx].}
Data Sheet
70
V2.3, 2003-11