TC11IB Datasheet, PDF (103/108 Pages) Infineon Technologies AG – 32-Bit Single-Chip Microcontroller

TC11IB
pin
1/2 in. max.
output buffer
1KΩ
10pF
1KΩ
V_DDP
Figure 41 Load Circuit for Slew Rate Measurement
PCI Clock Specification
(Operating Conditions apply; C_L = 10 pF)
Parameter
CLK Cycle Time
CLK High Time
CLK Low Time
CLK Slew Rate
Symbol Min.
t_CYC
30
t_HIGH 11
t_LOW
11
-
1
Max.
-
-
-
4
Units Notes
ns
1)
ns
ns
V/ns ²⁾
1) _{In general, the PCI component must work with any clock frequency between nominal DC and 33 MHz. Device}
operational parameters at frequencies under 16 MHz may be guaranteed by design rather than by testing. The
clock frequency may be changed at any time during the operation of the system so long as the clock edges
remain “clean” (monotonic) and the minimum cycle, high and low times are not violated. The clock may only
be stopped in a low state.
2) _{Rise and fall times are specified in terms of the edge rate measured in V/ns. This slew rate must be met across}
the minimum peak-to-peak portion of the clock waveform as shown in Figure 42.
0.5 V_DDP
0.4 V_DDP
0.3 V_DDP
t_HIGH
0.6 V_DDP
Figure 42 Clock Specification
Data Sheet
99
t_LOW
0.2 V_DDP
0.4V_DDP p-to-p (min)
V2.3, 2003-11