English
Language : 

HYB25L128160AC Datasheet, PDF (11/50 Pages) Infineon Technologies AG – 128-MBIT SYNCHRONOUS LOW-POWER DRAM IN CHIPSIZE PACKAGES
HYB/E 25L128160AC
128-MBit Mobile-RAM
Similar to the page mode of conventional DRAM’s, burst read or write accesses on any column
address are possible once the RAS cycle latches the sense amplifiers. The maximum WRAS or the
refresh interval time limits the number of random column accesses. A new burst access can be
done even before the previous burst ends. The interrupt operation at every clock cycle is supported.
When the previous burst is interrupted, the remaining addresses are overridden by the new address
with the full burst length. An interrupt which accompanies an operation change from a read to a write
is possible by exploiting DQM to avoid bus contention.
When two or more banks are activated sequentially, interleaved bank read or write operations are
possible. With the programmed burst length, alternate access and precharge operations on two or
more banks can realize fast serial data access modes among many different pages. Once two or
more banks are activated, column to column interleave operation can be performed between
different pages. When the partial array activation is set, data will get lost when self-refresh is used
in all non activated banks.
Burst Length and Sequence
Burst
Length
Starting
Address
(A2 A1 A0)
Sequential Burst
Addressing
(decimal)
2
xx0
0, 1
xx1
1, 0
4
x00
x01
x10
x11
0, 1, 2, 3
1, 2, 3, 0
2, 3, 0, 1
3, 0, 1, 2
8
000
01234567
001
12345670
010
23456701
011
34567012
100
45670123
101
56701234
110
67012345
111
70123456
Full Page
nnn
Cn, Cn+1, Cn+2
Interleave Burst
Addressing
(decimal)
0, 1
1, 0
0, 1, 2, 3
1, 0, 3, 2
2, 3, 0, 1
3, 2, 1, 0
01234567
10325476
23016745
32107654
45670123
54761032
67452301
76543210
not supported
Srs…r†uÃH‚qr
Mobile-RAM has two refresh modes, Auto Refresh and Self Refresh.
6 ˆ‡‚Srs…r†u
Auto Refresh is similar to the CAS -before-RAS refresh of earlier DRAMs. All banks must be
precharged before applying any refresh mode. An on-chip address counter increments the word
and the bank addresses. No bank information is required for both refresh modes.
INFINEON Technologies
11
2003-02