MC9S08DZ60MLF Datasheet, PDF (35/416 Pages) Freescale Semiconductor, Inc – MC9S08DZ60 Series Features

Chapter 3
Modes of Operation
3.1 Introduction
The operating modes of the MC9S08DZ60 Series are described in this chapter. Entry into each mode, exit
from each mode, and functionality while in each of the modes are described.
3.2 Features
• Active background mode for code development
• Wait mode — CPU shuts down to conserve power; system clocks are running and full regulation
is maintained
• Stop modes — System clocks are stopped and voltage regulator is in standby
— Stop3 — All internal circuits are powered for fast recovery
— Stop2 — Partial power down of internal circuits; RAM content is retained
3.3 Run Mode
This is the normal operating mode for the MC9S08DZ60 Series. This mode is selected when the
BKGD/MS pin is high at the rising edge of reset. In this mode, the CPU executes code from internal
memory with execution beginning at the address fetched from memory at 0xFFFE–0xFFFF after reset.
3.4 Active Background Mode
The active background mode functions are managed through the background debug controller (BDC) in
the HCS08 core. The BDC, together with the on-chip debug module (DBG), provide the means for
analyzing MCU operation during software development.
Active background mode is entered in any of five ways:
• When the BKGD/MS pin is low at the rising edge of reset
• When a BACKGROUND command is received through the BKGD/MS pin
• When a BGND instruction is executed
• When encountering a BDC breakpoint
• When encountering a DBG breakpoint
After entering active background mode, the CPU is held in a suspended state waiting for serial background
commands rather than executing instructions from the user application program.
MC9S08DZ60 Series Data Sheet, Rev. 4
Freescale Semiconductor
35