MC9S08DZ60MLF Datasheet, PDF (249/416 Pages) Freescale Semiconductor, Inc – MC9S08DZ60 Series Features

DLC3
0
0
0
0
0
0
0
0
1
Chapter 12 Freescale’s Controller Area Network (S08MSCANV1)
Table 12-33. Data Length Codes
Data Length Code
DLC2
0
0
0
0
1
1
1
1
0
DLC1
0
0
1
1
0
0
1
1
0
DLC0
0
1
0
1
0
1
0
1
0
Data Byte
Count
0
1
2
3
4
5
6
7
8
12.4.5 Transmit Buffer Priority Register (TBPR)
This register defines the local priority of the associated message transmit buffer. The local priority is used
for the internal prioritization process of the MSCAN and is defined to be highest for the smallest binary
number. The MSCAN implements the following internal prioritization mechanisms:
• All transmission buffers with a cleared TXEx flag participate in the prioritization immediately
before the SOF (start of frame) is sent.
• The transmission buffer with the lowest local priority field wins the prioritization.
In cases of more than one buffer having the same lowest priority, the message buffer with the lower index
number wins.
R
W
Reset:
7
PRIO7
0
6
PRIO6
5
PRIO5
4
PRIO4
3
PRIO3
2
PRIO2
0
0
0
0
0
Figure 12-35. Transmit Buffer Priority Register (TBPR)
1
PRIO1
0
0
PRIO0
0
Read: Anytime when TXEx flag is set (see Section 12.3.6, “MSCAN Transmitter Flag Register
(CANTFLG)”) and the corresponding transmit buffer is selected in CANTBSEL (see Section 12.3.10,
“MSCAN Transmit Buffer Selection Register (CANTBSEL)”).
Write: Anytime when TXEx flag is set (see Section 12.3.6, “MSCAN Transmitter Flag Register
(CANTFLG)”) and the corresponding transmit buffer is selected in CANTBSEL (see Section 12.3.10,
“MSCAN Transmit Buffer Selection Register (CANTBSEL)”).
12.4.6 Time Stamp Register (TSRH–TSRL)
If the TIME bit is enabled, the MSCAN will write a time stamp to the respective registers in the active
transmit or receive buffer as soon as a message has been acknowledged on the CAN bus (see
MC9S08DZ60 Series Data Sheet, Rev. 4
Freescale Semiconductor
249